We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

godream

godream 2000W CRPS Power Supply PWS-2K05A-1R

SKU CH-410K-ZTXTM

CRPS redundant 2000W power supply for Supermicro servers, tested and working

  • TypeATX
  • Tested working so the unit is ready to deploy
  • 2000W output handles dense server loads
  • ATX form factor fits standard CRPS bays
  • Good quality components support reliable operation

godream 2000W CRPS Power Supply

The godream PWS-2K05A-1R is a 2000W CRPS power supply built for Supermicro platforms. It uses an ATX form factor and arrives new from the manufacturer. Each unit is tested working before it ships. This unit suits operators who need a high-output, redundant-ready supply for compatible server chassis.

Thermals noise and power draw

The 2000W rating defines the maximum continuous output the supply can deliver. A 5-unit redundancy scheme is supported by the CRPS architecture for fault-tolerant deployments. Fan speed and acoustic output scale with the actual load placed on the unit. Power draw at the wall will match system demand up to the rated capacity.

Highlights

  • Tested working so the unit is ready to deploy
  • 2000W output handles dense server loads
  • ATX form factor fits standard CRPS bays
  • Good quality components support reliable operation

Specifications

TypeATX

Questions about this item

How is the 2000W CRPS unit installed in a Supermicro chassis?

Slide the PWS-2K05A-1R into the CRPS bay until the latch clicks, then secure the thumbscrew; the step most people miss is fully tightening that screw so the hot-plug connector seats completely.

What maintenance will the 2000W CRPS supply need later?

Clean the intake mesh every few months with compressed air and listen for fan bearing noise; the internal fan is the only wear item and can be replaced by sliding the unit out and swapping the fan module.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.