We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

myVolts

myVolts ATX-600W power supply

SKU CH-BR7V-6BEW4 MPN ATX-600W

A 600 W ATX power supply with active PFC, >80 % efficiency, a 14 cm thermally controlled fan, 20+4 pin motherboard connector, dual 4+4 pin CPU power.

  • TypeAT
  • 600W rated power supports basic desktop builds
  • Active full-voltage PFC delivers >80% efficiency
  • Thermal-sensor fan control keeps noise low
  • Clearly marked connectors simplify installation
  • Compact 150 x 160 x 86 mm form factor fits small cases

600W ATX power supply for basic desktops

The myVolts ATX-600W delivers 600W rated power in a compact 150 x 160 x 86mm frame. A 14cm thermally controlled fan adjusts speed automatically for low-noise operation. Active PFC supports 115/230V input without a manual switch. Efficiency exceeds 80 percent under typical loads.

Replaces older low-efficiency units

Builders upgrading from supplies without active PFC or 80-plus efficiency gain steadier voltage and reduced heat. The 20+4 pin motherboard connector and dual 4-pin CPU plugs fit most mainstream boards. Six SATA connectors and a 6+2 pin graphics cable cover standard drive and GPU needs. Hold-up time exceeds 10ms for brief power dips.

Capacity headroom for entry systems

The 600W rating comfortably powers a modern CPU, single mid-range graphics card, multiple SATA drives and case fans. Systems with dual high-end GPUs or extreme overclocks will exceed the available headroom. Rated lifespan reaches 100000 hours at normal operating temperatures.

Highlights

  • 600W rated power supports basic desktop builds
  • Active full-voltage PFC delivers >80% efficiency
  • Thermal-sensor fan control keeps noise low
  • Clearly marked connectors simplify installation
  • Compact 150 x 160 x 86 mm form factor fits small cases

Specifications

TypeAT

Questions about this item

Will the 150 x 160 x 86 mm dimensions fit a standard ATX case?

The unit measures 150 mm wide, 160 mm deep and 86 mm high, matching the standard ATX form factor used by most desktop cases.

Which cables must be connected during installation, and which step is often missed?

Connect the 20+4 pin motherboard cable, the 4+4 pin CPU cable, SATA drives and the 6+2 pin GPU cable; the 4+4 pin CPU connector is the step most often forgotten.

When should the 14 cm fan or the unit itself be replaced?

The fan is rated for 100000 hours of operation; if noise increases or the thermal sensor stops adjusting speed, plan a replacement around that interval.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.