We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Compact grey metal power supply unit with side ventilation slots and screw terminals

myVolts

myVolts SDP06-24-100T 24-28V 0.6A power supply

SKU CH-H4X7-5XVEA

Compact AT power supply delivering 24-28 V DC at 0.6 A from 85-264 V AC input, NEC Class 2 limited

  • TypeAT
  • Wide 85-264 V AC input handles global mains
  • NEC Class 2 current limiting protects against overloads
  • Compact 2.95 x 0.90 x 3.80 inch footprint saves space
  • 24-28 V DC adjustable output suits varied loads

Compact DIN-rail supply for low-current 24 V systems

This myVolts SDP06-24-100T unit delivers 24-28 V DC at 0.6 A from a universal 85-264 V AC or 90-375 V DC input. The 47-63 Hz single-phase design fits a 2.95 x 0.90 x 3.80 inch footprint and carries NEC Class 2 current-limited protection. It suits automation panels, sensor arrays and similar loads that need a steady, regulated rail without forced-air cooling.

Steady output under continuous 0.6 A draw

Because the supply is rated for the full 0.6 A continuously, voltage remains within the 24-28 V window during prolonged operation rather than sagging after a short burst. The wide input range absorbs mains fluctuation without triggering shutdown, and the Class 2 limit prevents fault currents from damaging downstream wiring. Installers should verify that the load never exceeds the rated current, as the unit has no parallel or redundancy provision.

Highlights

  • Wide 85-264 V AC input handles global mains
  • NEC Class 2 current limiting protects against overloads
  • Compact 2.95 x 0.90 x 3.80 inch footprint saves space
  • 24-28 V DC adjustable output suits varied loads

Specifications

TypeAT

Questions about this item

How much heat and noise does the SDP06-24-100T produce when running continuously?

The unit is a low-power 0.6 A supply with no fan, so it runs silently and generates only modest warmth during all-day operation.

What input wiring or connectors must I already have to install this power supply?

You need a 1-phase AC source between 85 and 264 V (or 90–375 V DC) and wiring suitable for the 2.95" × 0.90" × 3.80" chassis.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.