NEMIX RAM 8GB DDR3 1866 PC3-14900 CL13 1.35V 204-pin SODIMM laptop RAM
- 8GB
- 204-Pin DDR3 SO-DIMM
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
NEMIX RAM
Dual-channel 16 GB DDR3 SODIMM kit running at 1866 MHz with CL13 latency and 1.35 V or 1.50 V operation
Capacity 16GB (2 x 8GB)
This 16 GB kit supplies two 8 GB DDR3 SODIMM modules rated at 1866 MHz with CL13 latency. It targets owners of laptops, all-in-one PCs, small-form-factor desktops or NAS appliances that accept 204-pin unbuffered non-ECC memory and need a straightforward capacity increase.
Each module runs at 1.35 V or 1.50 V without a heat spreader, keeping power draw modest and thermals easy for compact chassis fans to manage. The unbuffered design adds no extra electrical load, so acoustic levels stay dictated by the host system rather than the memory itself.
Matched 2Rx8 organisation means the two sticks work together in dual-channel mode immediately after seating them in the slots. No software, drivers or configuration utilities are bundled; the performance gain comes purely from the added capacity and speed rating.
| Brand | NEMIX RAM |
|---|---|
| Series | NEMIX RAM DDR3 Orignial Series 204-Pin NON-ECC Unbuffered SODIMM Memory |
| Model | DDR3 NON- ECC Unbuffered SODIMM Laptop, AIO, SFF, NAS Storage Device Memory |
| Part Number | MS14900-828K2 |
| Capacity | 16GB (2 x 8GB) |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3 1866 (PC3 14900) |
| CAS Latency | CL13 |
| Voltage | 1.50V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Heat Spreader | No |
| Features | DDR3 Laptop, AIO All-in-One, SFF, NAS Device Compatible |
Other versions of this model
Same family, different memory, cooler or clock — compare before you commit.
Align the notch on each 204-Pin DDR3 SODIMM with the slot key, insert at an angle, then press down firmly until both side clips click into place; the step often missed is not pressing hard enough to fully engage both clips.
No routine maintenance is required for the unbuffered non-ECC modules; replacement is only needed if a module fails or if the system is upgraded beyond DDR3 technology.
The CL13 timing at DDR3 1866 speed sets the latency floor; under sustained loads the memory controller's bandwidth ceiling is reached before the modules themselves throttle.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
No language matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?