We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green 240-pin DDR3 UDIMM module, black chips, no heat spreader

NEMIX RAM

NEMIX RAM 4GB DDR3 1600 2Rx8 SNPVT8FPC/4G A6994459 240-Pin UDIMM

SKU CH-H635-YC5V7

A 4 GB DDR3 UDIMM running at 1600 MT/s with CL11 latency and 1.35 V operation

  • Capacity4GB
  • Type240-Pin DDR3 UDIMM
  • SpeedDDR3 1600 (PC3 12800)
  • CAS LatencyCL11
  • Voltage1.35V
  • ECCNo
  • 4GB DDR3 1600 module expands desktop memory capacity
  • CL11 latency at 1600MHz supports responsive system operation
  • 35V low-voltage DDR3 reduces power draw versus standard 1.5V parts
  • Unbuffered non-ECC 240-pin UDIMM fits standard desktop motherboards
  • Built with Samsung Micron Hynix chips and stress-tested for stability

4GB DDR3 1600 UDIMM for desktop upgrades

This 4 GB DDR3 1600 module uses the standard 240-pin UDIMM form factor and runs at 1.35 V with CL11 latency. It is built for desktop boards that accept non-ECC unbuffered memory and is validated against the Dell SNPVT8FPC/4G A6994459 part number.

Major OEM chips tested under load

Samsung Micron or Hynix DRAM components are assembled on each stick and then stress tested at full load before shipping. That validation step replaces the usual guesswork when mixing modules and reduces the chance of boot failures or data errors.

1.35 V operating voltage

The module operates at 1.35 V rather than the older 1.5 V DDR3 standard. If your motherboard or BIOS only supports 1.5 V operation this stick may not post or may run at reduced speed so verify the board's voltage capability before purchase.

Highlights

  • 4GB DDR3 1600 module expands desktop memory capacity
  • CL11 latency at 1600MHz supports responsive system operation
  • 35V low-voltage DDR3 reduces power draw versus standard 1.5V parts
  • Unbuffered non-ECC 240-pin UDIMM fits standard desktop motherboards
  • Built with Samsung Micron Hynix chips and stress-tested for stability

Specifications

BrandNEMIX RAM
SeriesNEMIX RAM DDR3 Orignial Desktop PC 240-Pin Non-ECC Unbuffered UDIMM Memory
ModelOriginal Series DDR3 Desktop PC Memory Solutions
Part NumberMD12800-428LK1
Capacity4GB
Type240-Pin DDR3 UDIMM
SpeedDDR3 1600 (PC3 12800)
CAS LatencyCL11
Voltage1.35V
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
FeaturesDDR3 Non-ECC Unbuffered UDIMM Motherboard Compatible
LED ColorNone

Questions about this item

Will the 240-pin DDR3 module need any re-seating or cleaning after long-term use?

Standard UDIMM contacts benefit from occasional re-seating to clear oxidation; no moving parts or heat spreader mean no scheduled replacement is required.

What limit appears first when the CL11 1600 MT/s stick runs sustained workloads?

The single 4 GB capacity caps multitasking headroom before the CL11 latency or 1.35 V operation becomes a bottleneck.

How much heat or fan noise does the unbuffered 1.35 V module add during all-day operation?

Low 1.35 V draw and no heat spreader keep thermal output minimal; it adds virtually no audible noise to a typical desktop chassis.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.