OWC 4GB DDR4 2133MHz CL15 1.2V 260pin SODIMM for Dell Inspiron 17 5765 5767 7778 7779
- 4GB
- 260-Pin DDR4 Non-EC…
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
OWC
4GB DDR4 2133MHz CL15 1.2V 260-pin SODIMM upgrade for HP 17-x series laptops
This 4 GB DDR4 SODIMM is built for HP 17-x005nl, 17-x005ns, 17-x006na, 17-x006nm and 17-x007cy notebooks. It suits owners of those models who need a straightforward capacity increase for everyday multitasking. Buyers with other laptops or desktops cannot use this module.
The module uses a standard 260-pin SODIMM edge connector with no heat spreader, so it slides into the factory memory slot without clearance issues. Operation at 1.2 V matches the JEDEC DDR4 baseline and keeps power draw low. The single-rank 1Rx8 organisation is compatible with the chipset memory controller in the listed HP systems.
Swapping an existing 2 GB or lower-speed DDR4 module for this CL15 2133 MHz unit raises bandwidth and reduces swap-file reliance. The jump is worthwhile when the system currently runs with a single channel or hits memory limits during typical workloads. It does not help if the board already has two populated slots or requires a higher density per slot.
| Brand | OWC |
|---|---|
| Part Number | 2S1D41R804GB |
| Capacity | 4GB |
| Type | 260-Pin DDR4 Non-ECC SODIMM |
| Speed | DDR4 2133 (PC4 17000) |
| CAS Latency | CL15 |
| Voltage | 1.2V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 1Rx8 |
| Heat Spreader | No |
| Compatible System | HP 17-x005nl HP 17-x005ns HP 17-x006na HP 17-x006nm HP 17-x007cy |
Other versions of this model
Same family, different memory, cooler or clock — compare before you commit.
The module operates at 2133MHz with CL15 latency and 1.2V voltage, matching the JEDEC DDR4 standard for that speed grade.
Yes, the 260-pin DDR4 SODIMM form factor matches the slot used in the listed HP 17 models including the 17-x006na.
Power off the laptop, remove the battery if accessible, open the memory compartment, align the notch on the 260-pin module with the slot key, press firmly until the side clips click, then reassemble and power on.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
No language matches that.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?