We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green rectangular circuit board with gold edge connector and black memory chips on both sides

OWC

OWC 8GB DDR4 3200 CL22 1Rx8 UDIMM memory upgrade for QNAP TS-877XU TS-877XU-RP TS-1277XU-RP TS-1677XU-RP

SKU CH-8R79-PYN38

8 GB DDR4 3200 CL22 non-ECC UDIMM for QNAP TS-877XU, TS-877XU-RP, TS-1277XU-RP and TS-1677XU-RP NAS systems

  • Capacity8GB
  • Type288-Pin DDR4 Non-ECC UDIMM
  • SpeedDDR4 3200 (PC4 25600)
  • CAS LatencyCL22
  • Voltage1.2V
  • ECCNo
  • 8GB capacity expands NAS multitasking headroom
  • DDR4 3200 CL22 speed matches system spec
  • 2V low-voltage operation reduces power draw
  • 288-pin UDIMM form factor fits QNAP bays
  • Backward compatible with 2133 2400 2666 2933 MHz systems

8GB DDR4 3200 UDIMM for QNAP NAS

This 8GB DDR4 3200 module is built as a direct memory upgrade for QNAP TS-877XU, TS-877XU-RP, TS-1277XU-RP and TS-1677XU-RP systems. It uses a 288-pin unbuffered UDIMM form factor and operates at 1.2V with CL22 latency. The single 1Rx8 rank module replaces QNAP part number RAM-8GDR4T0-UD-3200 and meets JEDEC specifications.

Suits owners of listed QNAP models adding capacity

Buyers with compatible QNAP NAS units can install this module to increase system memory for multitasking and larger workloads. The non-ECC unbuffered design matches the factory specification for these models. This module is not for systems that require ECC registered memory or a different DDR generation. It also does not suit builds needing speeds above 3200MHz or capacities beyond a single 8GB stick.

Check your NAS model and empty DIMM slots

Verify the exact model number on your QNAP chassis matches one of the four listed series before ordering. Confirm the motherboard has an available 288-pin DDR4 UDIMM slot and that the system BIOS supports 3200MHz operation with CL22 timing. The module is backward compatible with 2133MHz, 2400MHz, 2666MHz and 2933MHz bus speeds if the platform runs at a lower frequency.

Highlights

  • 8GB capacity expands NAS multitasking headroom
  • DDR4 3200 CL22 speed matches system spec
  • 2V low-voltage operation reduces power draw
  • 288-pin UDIMM form factor fits QNAP bays
  • Backward compatible with 2133 2400 2666 2933 MHz systems

Specifications

BrandOWC
Part Number3U2D41R808GB
Capacity8GB
Type288-Pin DDR4 Non-ECC UDIMM
SpeedDDR4 3200 (PC4 25600)
CAS LatencyCL22
Voltage1.2V
ECCNo
Buffered/RegisteredUnbuffered
Rank1Rx8
Heat SpreaderNo
Compatible SystemQNAP TS-877XU
QNAP TS-877XU-RP
QNAP TS-1277XU-RP
QNAP TS-1677XU-RP

Other versions of this model

5 more in the same range

Same family, different memory, cooler or clock — compare before you commit.

Questions about this item

Does my QNAP TS-877XU need an empty 288-pin DDR4 UDIMM slot for this 8GB module?

Yes, the module is a 288-pin DDR4 UDIMM and requires a free UDIMM slot in the NAS.

Will this 3200MHz CL22 stick run stably alongside my existing 2666MHz DDR4 memory?

The module is backward compatible with 2666MHz, 2400MHz, 2133MHz and 2933MHz speeds, so it will operate at the lowest common speed.

How can I confirm the NAS recognises the full 8GB at 3200MHz after installation?

Check the system information or resource monitor in the QNAP OS; it will show 8GB total capacity and the running memory speed.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.