RIMLANCE
RIMLANCE 16GB (2x8GB) DDR4 2666 CL19 1.2V UDIMM desktop RAM
A 16GB dual-channel DDR4 kit running at 2666MHz with CL19 latency and 1.2V operation for standard desktop upgrades
- Capacity16GB (2 x 8GB)
- Type288-Pin PC RAM
- SpeedDDR4 2666 (PC4 21300)
- CAS LatencyCL19
- ECCNo
- Buffered/RegisteredUnbuffered
- 16 GB dual-channel kit enables smooth multitasking
- 2666 MHz DDR4 speed delivers responsive everyday performance
- CL19 latency supports stable system operation
- 2 V standard voltage reduces power draw and heat
- 288-pin UDIMM fits most consumer desktop motherboards
16GB DDR4 kit for desktop upgrades
This RIMLANCE kit provides 16GB of memory as two 8GB UDIMM modules built for DDR4 platforms. It targets users who want a straightforward capacity increase for everyday multitasking and office workloads. The unbuffered, non-ECC design matches standard consumer motherboard requirements. Installation follows the usual 288-pin DIMM procedure without extra configuration steps.
Thermals noise and power at 1.2V
Operating at the standard 1.2V DDR4 voltage, the modules draw minimal power and produce little heat during typical desktop use. No active cooling is required and the sticks run silently inside the case. The low voltage also helps keep overall system power draw modest under normal multitasking loads. Stable operation is maintained at the rated 2666MHz speed with CL19 latency.
Replaces older DDR4 sticks or fills empty slots
This kit upgrades systems running slower DDR4 speeds or smaller capacities such as single 8GB modules. The jump is worthwhile when the motherboard supports 2666MHz and the user needs more headroom for browser tabs, office suites or light content creation. It does not suit builds that require ECC, registered DIMMs or speeds beyond the PC4-21300 rating.
Highlights
- 16 GB dual-channel kit enables smooth multitasking
- 2666 MHz DDR4 speed delivers responsive everyday performance
- CL19 latency supports stable system operation
- 2 V standard voltage reduces power draw and heat
- 288-pin UDIMM fits most consumer desktop motherboards
Specifications
| Brand | RIMLANCE |
|---|---|
| Model | RUD21300S6C2K16 |
| Capacity | 16GB (2 x 8GB) |
| Type | 288-Pin PC RAM |
| Speed | DDR4 2666 (PC4 21300) |
| CAS Latency | CL19 |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Chipset | Major Brand Chipset |
Questions about this item
How do I install these 288-pin DDR4 UDIMM modules and what is the common mistake?
Align the notch on each 288-pin module with the slot key, press straight down until both retention clips click, and ensure the motherboard is powered off; the common mistake is seating only one side so the clip on the other side stays open.
What maintenance or replacement will this 16GB kit need over time?
No scheduled maintenance is required; keep the gold contacts clean and ensure case airflow stays adequate. If a module fails, replace the faulty 8GB stick with another DDR4 2666 CL19 1.2V UDIMM of matching capacity.
What limit appears first when this memory runs at 2666MHz under sustained load?
The CAS latency of CL19 at 1.2V sets the timing floor; under continuous heavy throughput the fixed latency and voltage become the bottleneck before thermal limits on standard unbuffered DDR4 modules.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
PrimoChill
PrimoChill Praxis Wetbench Open-Air Test Bench 461.8mm
- Open-Air
$274.89
0.00355238BTC
In stock
Silverstone Technology
SilverStone Technology Strider 1200W 80 Plus Platinum Modular Power Supply
- ATX Mid Tower
- 1200W
$324.03
0.00418741BTC
In stock