Simmtec, Inc
Simmtec, Inc 12GB 6x2GB DDR3 2000 MHz CL9 240pin 1.65v
A 12 GB DDR3 desktop kit running at 2000 MHz with CL9 latency, supplied as six 2 GB 240-pin DIMMs at 1.65 V
- Capacity2GB
- CAS LatencyCL9
- 12 GB total capacity from six matched 2 GB modules
- DDR3 2000 MHz rated speed for responsive desktop performance
- CL9 latency timing supports quick data access
- 240-pin DIMM form factor fits standard desktop slots
- 65 V operating voltage matches module specification
12 GB DDR3 Kit for Desktop Systems
This kit provides twelve gigabytes of DDR3 memory across six modules, each rated at two gigabytes. The modules operate at 2000 MHz with a CAS latency of CL9 and require 1.65 volts. They use the standard 240-pin DIMM form factor for desktop motherboards.
Suits Enthusiasts Building High-Capacity DDR3 Rigs
Builders who need a large 12 GB configuration on a platform limited to DDR3 will find this six-module kit convenient. Systems restricted to lower voltages or fewer memory slots should look elsewhere, as each module draws 1.65 volts and all six slots must be populated.
Fits Standard 240-Pin DDR3 Motherboards
The modules install directly into any desktop board with six available 240-pin DDR3 slots and support for 1.65-volt operation. Populating every slot leaves no room for future expansion, so the full capacity is available immediately without adding more sticks later.
Highlights
- 12 GB total capacity from six matched 2 GB modules
- DDR3 2000 MHz rated speed for responsive desktop performance
- CL9 latency timing supports quick data access
- 240-pin DIMM form factor fits standard desktop slots
- 65 V operating voltage matches module specification
Specifications
| Capacity | 2GB |
|---|---|
| CAS Latency | CL9 |
Questions about this item
Does my motherboard need to support 1.65 V DDR3 for this 6×2 GB kit to run at 2000 MHz?
Yes. The modules are rated at 1.65 V and 2000 MHz CL9, so the board must supply that voltage and accept DDR3 at that speed for the kit to operate at its specified frequency.
Can I keep my existing DDR3 DIMMs installed alongside these six 2 GB sticks?
Only if the motherboard has enough free 240-pin slots and can run all modules at the same voltage and timing; mixing kits with different voltages or speeds will force the system to the lowest common settings.
How do I confirm the kit is running at 2000 MHz CL9 after installation?
Check the memory frequency and timings in the BIOS or a system-information tool such as CPU-Z; they should report 2000 MHz (PC3-16000) with CAS latency 9 when the kit is operating as specified.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
PrimoChill
PrimoChill Praxis Wetbench Open-Air Test Bench 461.8mm
- Open-Air
$274.89
0.00355155BTC
In stock
Silverstone Technology
SilverStone Technology Strider 1200W 80 Plus Platinum Modular Power Supply
- ATX Mid Tower
- 1200W
$324.03
0.00418643BTC
In stock