Unique-Bargains
Unique-Bargains 1.75 mm PLA Filament Orange 10 m 3D Printers Accessory
1.75 mm PLA filament on a 10 m spool with ±0.03 mm accuracy for smooth, low-warp orange prints
- TypeTubes
- Stable output from high-purity PLA base material
- Smooth prints free of bubbles and blistering
- Accurate 1.75 mm diameter with ±0.02 mm precision
- Warp-free results with strong tensile strength and low shrinkage
- Eco-friendly PLA sourced from renewable plant starches
What this filament is for
This 10 m spool of 1.75 mm orange PLA filament is suited for hobbyists and makers who need a short length of material for test prints, calibration or small projects. It works with any 3D printer that accepts 1.75 mm filament and does not require a heated bed.
Practical limits of 1.75 mm PLA
The filament is specified at 1.75 mm diameter with a dimensional accuracy of +/- 0.03 mm. PLA prints at lower temperatures than many other thermoplastics and does not need a heated build plate, but it softens at relatively low heat so printed parts can deform in hot environments.
The spec that decides fit
The critical figure is the 1.75 mm diameter with +/- 0.02 mm precision. If your printer uses a different filament size or demands tighter tolerance, this spool will not feed reliably.
Highlights
- Stable output from high-purity PLA base material
- Smooth prints free of bubbles and blistering
- Accurate 1.75 mm diameter with ±0.02 mm precision
- Warp-free results with strong tensile strength and low shrinkage
- Eco-friendly PLA sourced from renewable plant starches
Specifications
| Brand | Unique Bargains |
|---|---|
| Type | Tubes |
Questions about this item
Should I pick the 10 m spool or a longer length for my first prints?
The 10 m length supplies roughly 34 g of PLA, enough for several small test models or calibration pieces before committing to a full kilogram spool.
What does the 1.75 mm diameter with ±0.03 mm accuracy mean once the filament is in my printer?
It keeps extrusion consistent across the hot-end, reducing clogs and giving smoother layer lines on finished parts.
Will the 1.75 mm spec work with every printer that takes 1.75 mm filament?
Yes, the tolerance of ±0.02 mm fits the standard 1.75 mm feed path used by most desktop FDM machines.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
