Aceitamos criptomoeda — para que as moedas que detém possam comprar material informático real.Pague em cripto, gaste-a em material informático real. Envio seguro gratuito para todo o mundo acima de 399 $. Caixas neutras, sem marca, expedidas a partir da Alemanha.Envio seguro gratuito acima de 399 $. A sua taxa fica bloqueada durante 30 minutos assim que abre a finalização da compra.Taxa bloqueada 30 minutos. Cada artigo é selado, o seu número de série é verificado, e está coberto por uma garantia de 24 meses.Selado, garantido 24 meses.

Artigos guardados Iniciar sessão

Dogfish Technology

Dogfish Technology mSATA 1TB internal SSD

SKU CH-W538-RGMP7

A 1 TB mSATA internal SSD with 3D NAND, SATA interface, up to 550 MB/s read and 450 MB/s write

  • Device TypeInternal Solid State Drive (SSD)
  • Used ForConsumer
  • Form FactormSATA
  • Capacity1TB
  • Memory Components3D NAND
  • InterfaceSATA III
  • 1TB capacity fits large libraries and backups
  • Up to 550 MB/s read and 450 MB/s write speeds accelerate everyday tasks
  • 3D NAND TLC flash improves endurance and density
  • mSATA 30 mm × 50.9 mm form factor suits compact laptops and desktops
  • Built-in ECC, bad-block management and DevSleep low-power state protect data and extend battery life

Dogfish 1 TB mSATA SSD

The Dogfish mSATA-1TB is an internal solid-state drive built for consumer laptops and desktops that accept the mSATA form factor. It uses 3D NAND flash and a SMI controller on a SATA III 6 Gb/s interface to deliver up to 550 MBps sequential read and 450 MBps sequential write. The drive measures 30 mm by 50 mm with a 1 mm profile and weighs 0.05 g. It is rated for 1,000,000 hours MTBF and operates from 0 °C to 75 °C.

Thermals noise and power in normal use

With no moving parts the drive produces no audible noise and adds minimal heat to the system during typical workloads. The controller supports DevSleep for an ultra low power state when the host is idle, and the 3D NAND structure helps reduce cell-to-cell interference for steady reliability. Operating humidity tolerance spans 0 % to 95 % non-condensing.

Sustained load behaviour

Under continuous read and write activity the drive maintains its rated sequential speeds of up to 550 MBps read and 450 MBps write within the 0 °C to 75 °C operating window. Built-in ECC, wear levelling and bad block management work together to preserve data integrity during prolonged transfers. The drive also supports SMART, TRIM and NCQ commands to optimise performance over time.

Pontos fortes

  • 1TB capacity fits large libraries and backups
  • Up to 550 MB/s read and 450 MB/s write speeds accelerate everyday tasks
  • 3D NAND TLC flash improves endurance and density
  • mSATA 30 mm × 50.9 mm form factor suits compact laptops and desktops
  • Built-in ECC, bad-block management and DevSleep low-power state protect data and extend battery life

Especificações

BrandTHREE COLOUR DOGFISH
SeriesmSATA-1TB
ModelmSATA-1TB
Device TypeInternal Solid State Drive (SSD)
Used ForConsumer
Form FactormSATA
Capacity1TB
Memory Components3D NAND
InterfaceSATA III
ControllerSMI
Max Sequential ReadUp to 550 MBps
Max Sequential WriteUp to 450 MBps
MTBF1,000,000 hours
Operating Temperature0°C ~ +75°C
Storage Temperature-45°C ~ +85°C
Operating Humidity0% ~ 95%
Height30mm
Width50mm
Depth1mm
Weight0.05g

Outras versões deste modelo

Mais 5 nesta gama

Mesma família, memória, ventoinha ou frequência diferentes — compare antes de decidir.

Perguntas sobre este artigo

How do I install the Dogfish mSATA 1TB SSD into a laptop slot, and what alignment step is often missed?

Insert the 30mm by 50.9mm board at a slight angle into the mSATA connector, press down until the retention clips click on both sides, then secure with the single mounting screw; skipping the screw leaves the drive loose and can break the SATA III link.

What maintenance or replacement will the 1TB 3D NAND drive need over its service life?

No scheduled maintenance is required; the SMI controller handles wear levelling, bad-block management and ECC automatically, and the 1,000,000-hour MTBF rating indicates the drive itself is the only replaceable part if it eventually fails.

At what point does the 550 MB/s sequential read speed stop scaling under sustained heavy workloads?

The SATA III 6 Gb/s interface caps sustained throughput at roughly 550 MB/s read and 450 MB/s write, so the bus limit is reached before the 3D NAND or controller throttles under continuous load.

Também nesta secção

Os clientes também compararam

Mesma prateleira, mesma finalização da compra — oito moedas e uma taxa bloqueada durante 30 minutos.