Aceitamos criptomoeda — para que as moedas que detém possam comprar material informático real.Pague em cripto, gaste-a em material informático real. Envio seguro gratuito para todo o mundo acima de 399 $. Caixas neutras, sem marca, expedidas a partir da Alemanha.Envio seguro gratuito acima de 399 $. A sua taxa fica bloqueada durante 30 minutos assim que abre a finalização da compra.Taxa bloqueada 30 minutos. Cada artigo é selado, o seu número de série é verificado, e está coberto por uma garantia de 24 meses.Selado, garantido 24 meses.

Artigos guardados Iniciar sessão
Green printed circuit board with black memory chips and gold edge connectors

NEMIX RAM

NEMIX RAM 128GB DDR5 5600 CL46 2Rx4 1.1V RDIMM Supermicro H13SST-GC memory upgrade

SKU CH-V87G-YGTBA

128 GB DDR5 5600 RDIMM with ECC and registered buffering, validated for the Supermicro H13SST-GC motherboard

  • Capacity128GB
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes

Size 128GB

Ver as outras 24 configurações
  • 128 GB capacity expands server memory headroom
  • DDR5 5600 speed matches controller-rated frequency
  • CL46 latency and 1.1 V voltage align with board expectations
  • 2Rx4 registered ECC design enables full-slot population with error correction
  • 288-pin RDIMM form factor fits Supermicro H13SST-GC memory slots

Exact-match server upgrade

This 128 GB DDR5 RDIMM is built for the Supermicro H13SST-GC motherboard. It delivers registered ECC memory that the board's controller recognises at full capacity and rated speed. System integrators and IT teams can populate every slot without mixing ranks or voltages.

Thermals noise and power

The modules run at 1.1 V with no heat spreader, relying on the server's directed airflow for cooling. Registered buffering reduces electrical load on the memory controller, keeping power draw predictable under sustained workloads. Silent operation is assured because there are no active cooling components on the DIMMs themselves.

2Rx4 registered ECC configuration

The dual-rank x4 organisation with CL46 timing is the specific layout the H13SST-GC memory population rules require. Using a different rank structure or unbuffered DIMMs would prevent the system from booting or reaching the rated 5600 MT/s data rate. Verify your manual for approved slot order before installation.

Pontos fortes

  • 128 GB capacity expands server memory headroom
  • DDR5 5600 speed matches controller-rated frequency
  • CL46 latency and 1.1 V voltage align with board expectations
  • 2Rx4 registered ECC design enables full-slot population with error correction
  • 288-pin RDIMM form factor fits Supermicro H13SST-GC memory slots

Especificações

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR44800-724K1
Capacity128GB
Type288-Pin DDR5 RDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content128GB DDR5 5600MHz PC5-44800 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Outras versões deste modelo

Mais 5 nesta gama

Mesma família, memória, ventoinha ou frequência diferentes — compare antes de decidir.

Perguntas sobre este artigo

How do I install this 288-pin DDR5 RDIMM in my Supermicro H13SST-GC, and which step is often missed?

Power down, open the chassis, and insert the module into the correct DIMM slot following the motherboard's population order; the step most often missed is checking the manual for the approved slot sequence before seating the RDIMM.

What maintenance or replacement will this 128GB ECC Registered module need over time?

No routine maintenance is required; if a correctable error rate rises or a module fails, replace the individual RDIMM — ECC corrects single-bit errors on the fly, but a defective unit must be swapped out.

What limit appears first when this CL46 1.1V kit runs sustained workloads?

The registered buffer and ECC logic keep every slot stable at the rated 5600 speed, so the first limit is the motherboard's maximum supported capacity or slot count, not the memory's own timing or voltage.

Também nesta secção

Os clientes também compararam

Mesma prateleira, mesma finalização da compra — oito moedas e uma taxa bloqueada durante 30 minutos.