Aceitamos criptomoeda — para que as moedas que detém possam comprar material informático real.Pague em cripto, gaste-a em material informático real. Envio seguro gratuito para todo o mundo acima de 399 $. Caixas neutras, sem marca, expedidas a partir da Alemanha.Envio seguro gratuito acima de 399 $. A sua taxa fica bloqueada durante 30 minutos assim que abre a finalização da compra.Taxa bloqueada 30 minutos. Cada artigo é selado, o seu número de série é verificado, e está coberto por uma garantia de 24 meses.Selado, garantido 24 meses.

Artigos guardados Iniciar sessão
Two green DDR5 RDIMM modules, 288-pin, no heat spreader

NEMIX RAM

NEMIX RAM 64GB (2×32GB) DDR5 6400 CL52 2Rx8 ECC Registered RDIMM Supermicro H13SST-G memory upgrade

SKU CH-BQ7H-WB8K9

A 64 GB DDR5-6400 ECC Registered RDIMM kit built for the Supermicro H13SST-G motherboard

  • Capacity64GB (2 x 32GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 6400 (PC5 51200)
  • CAS LatencyCL52
  • Voltage1.10V
  • ECCYes
  • Exact DDR5-6400 CL52 2Rx8 spec so the Supermicro H13SST-G recognizes full 64 GB capacity
  • Registered ECC RDIMM design offloads the controller and corrects single-bit errors for enterprise stability
  • 10 V operation matches the board's voltage requirement for reliable full-population performance
  • 288-pin RDIMM form factor fits the H13SST-G DIMM slots without adapters or mismatches
  • Lifetime replacement warranty with US-based technical support backs the upgrade long-term

64 GB DDR5 RDIMM kit for Supermicro H13SST-G

This 64 GB kit contains two 32 GB DDR5 registered ECC modules built for the Supermicro H13SST-G motherboard. It targets administrators who need to populate every DIMM slot with validated registered memory that runs at the board’s rated speed without manual tuning.

2Rx8 registered ECC at 1.1 V CL52

Each module is a 288-pin DDR5 RDIMM organised as 2Rx8, operating at DDR5 6400 (PC5-51200) with a CAS latency of 52 at 1.1 V. The registered buffer and on-die ECC let the memory controller drive a fully populated configuration while correcting single-bit errors before they reach the operating system.

Fits Supermicro H13SST-G 288-pin RDIMM slots

The kit matches the board’s required 288-pin registered form factor and population rules, freeing you from mixing unbuffered or SODIMM modules that the platform cannot recognise. Verify the motherboard manual for approved slot order and maximum supported capacity before installation.

Pontos fortes

  • Exact DDR5-6400 CL52 2Rx8 spec so the Supermicro H13SST-G recognizes full 64 GB capacity
  • Registered ECC RDIMM design offloads the controller and corrects single-bit errors for enterprise stability
  • 10 V operation matches the board's voltage requirement for reliable full-population performance
  • 288-pin RDIMM form factor fits the H13SST-G DIMM slots without adapters or mismatches
  • Lifetime replacement warranty with US-based technical support backs the upgrade long-term

Especificações

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR51200-328K2
Capacity64GB (2 x 32GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 6400 (PC5 51200)
CAS LatencyCL52
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content64GB 2X32GB DDR5 6400MHz PC5-51200 2Rx8 1.1V 288-PIN ECC RDIMM KIT

Perguntas sobre este artigo

Will the 6400 MT/s speed run at that rate on the Supermicro H13SST-G?

The kit is specified at DDR5-6400 (PC5-51200) with CL52 timings. When installed in the H13SST-G, the memory controller will recognize the exact rank, voltage and timing profile, allowing the modules to operate at their rated 6400 MT/s speed.

Does the 288-pin RDIMM form factor match the board's DIMM slots?

Yes. The H13SST-G requires 288-pin Registered (RDIMM) DDR5 modules. This kit uses that exact form factor — not UDIMM or SODIMM — so it fits the board's DIMM slots and follows the motherboard's population rules.

What physical clearance do the 32 GB modules need inside the chassis?

Each 32 GB module is a standard-height 288-pin RDIMM without a heat spreader. They occupy one DIMM slot each and require only the normal vertical clearance for a registered DDR5 DIMM in a server chassis.

Também nesta secção

Os clientes também compararam

Mesma prateleira, mesma finalização da compra — oito moedas e uma taxa bloqueada durante 30 minutos.