Aceitamos criptomoeda — para que as moedas que detém possam comprar material informático real.Pague em cripto, gaste-a em material informático real. Envio seguro gratuito para todo o mundo acima de 399 $. Caixas neutras, sem marca, expedidas a partir da Alemanha.Envio seguro gratuito acima de 399 $. A sua taxa fica bloqueada durante 30 minutos assim que abre a finalização da compra.Taxa bloqueada 30 minutos. Cada artigo é selado, o seu número de série é verificado, e está coberto por uma garantia de 24 meses.Selado, garantido 24 meses.

Artigos guardados Iniciar sessão
Eight green DDR5 RDIMM sticks with black chips and gold contacts, no heat spreaders

NEMIX RAM

NEMIX RAM DDR5 1TB 8x128GB 4800MHz CL40 1.1V 2Rx4 ECC RDIMM Supermicro H13SSL-N memory upgrade

SKU CH-V54K-3XNF1

1 TB kit of eight 128 GB DDR5 4800 MHz CL40 1.1 V 2Rx4 ECC registered RDIMMs validated for the Supermicro H13SSL-N motherboard

  • Capacity1TB (8 x 128GB)
  • Type288-Pin DDR5 RDIMM
  • SpeedDDR5 4800 (PC5 38400)
  • CAS LatencyCL40
  • Voltage1.10V
  • ECCYes

Size 1TB 8X128GB

Ver as outras 24 configurações
  • 1TB capacity across eight 128GB modules for maximum memory density
  • DDR5 4800MHz CL40 at 1.1V delivers rated speed without tuning
  • Registered ECC 2Rx4 architecture offloads controller and corrects single-bit errors
  • 288-pin RDIMM form factor matches Supermicro H13SSL-N slot requirements exactly
  • Major OEM Samsung, Micron, Hynix chips ensure enterprise-grade component quality

Exact-match DDR5 server kit

This 1TB kit contains eight 128GB DDR5 registered ECC RDIMMs built to the exact rank, voltage, and timing the Supermicro H13SSL-N motherboard expects. The modules install in the 288-pin slots and are recognised at full capacity without manual configuration. Buyers who need unbuffered UDIMMs or SODIMM form factors cannot use this kit.

Sustained-load stability

Registered buffering offloads the memory controller so every slot runs fully populated at the rated 4800 speed, while ECC corrects single-bit errors on the fly to prevent silent data corruption. The 1.1V operating voltage keeps power draw predictable during continuous workloads. Systems that require higher frequencies or lower latencies than CL40 will not reach those targets with this memory.

Installation and common issues

The 288-pin RDIMMs seat in the board's DDR5 slots following the population order shown in the motherboard manual. Missing a required BIOS update or populating slots in the wrong sequence are the usual reasons the full 1TB is not detected. Builders without access to the system documentation should verify the supported configuration before opening the package.

Pontos fortes

  • 1TB capacity across eight 128GB modules for maximum memory density
  • DDR5 4800MHz CL40 at 1.1V delivers rated speed without tuning
  • Registered ECC 2Rx4 architecture offloads controller and corrects single-bit errors
  • 288-pin RDIMM form factor matches Supermicro H13SSL-N slot requirements exactly
  • Major OEM Samsung, Micron, Hynix chips ensure enterprise-grade component quality

Especificações

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR5 ECC RDIMM Registered Server Memory
Part NumberMR38400-724K8
Capacity1TB (8 x 128GB)
Type288-Pin DDR5 RDIMM
SpeedDDR5 4800 (PC5 38400)
CAS LatencyCL40
Voltage1.10V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC RDIMM Motherboard Compatible
Package Content1TB 8X128GB DDR5 4800MHz PC5-38400 2Rx4 1.1V 288-PIN ECC RDIMM KIT

Outras versões deste modelo

Mais 5 nesta gama

Mesma família, memória, ventoinha ou frequência diferentes — compare antes de decidir.

Perguntas sobre este artigo

How much heat and power does the 1TB DDR5 kit draw when all eight 128GB modules run continuously?

Each module operates at 1.1V with DDR5 4800 speed and CL40 timing; the registered design reduces electrical load on the memory controller, helping keep power draw and heat predictable across all eight slots.

What motherboard and memory-controller features must my system already have for this 288-pin RDIMM kit to function?

The Supermicro H13SSL-N motherboard with DDR5 registered DIMM slots and ECC support is required; the board must accept 2Rx4 128GB modules at 4800MHz and 1.1V.

Will the 2Rx4 registered ECC modules work alongside any existing DDR5 RDIMMs I keep in the H13SSL-N?

Mixing ranks or capacities can change the memory-controller population rules; consult the H13SSL-N manual for approved DIMM order before adding this 8x128GB kit to installed modules.

Também nesta secção

Os clientes também compararam

Mesma prateleira, mesma finalização da compra — oito moedas e uma taxa bloqueada durante 30 minutos.