NEMIX RAM 16GB DDR4 3200 CL22 1.2V 260-Pin SODIMM Laptop RAM

16 GB DDR4 SODIMM for Laptop Upgrades

This single 16 GB module uses the 260-pin DDR4 SO-DIMM form factor and runs at 3200 MT/s with CL22 latency at 1.2 V. It targets owners of laptops, all-in-one PCs, small-form-factor desktops or NAS devices that accept non-ECC unbuffered memory. The 2Rx8 organisation provides the density needed for multitasking and memory-hungry applications.

Straightforward Slot-In Installation

Installation typically takes a few minutes: power down the device, open the memory access panel, align the notch on the 260-pin edge connector and press firmly until the retention clips engage. The most common issue is a module not seated fully, which causes the system to fail POST or show no memory detected. Reseating usually resolves this. Systems locked to lower speeds will run the module at the highest supported JEDEC rate.

16 GB Capacity with DDR4-3200 Headroom

The 16 GB capacity handles everyday workloads, virtual machines and large datasets without paging to slower storage. At 3200 MT/s the module delivers ample bandwidth for integrated and discrete graphics alike. Headroom ends when the platform’s memory controller caps the data rate below 3200 MT/s or when the total installed memory reaches the board’s maximum supported capacity.