A-Tech 8GB DDR3 1600 ECC RDIMM 2Rx8 1.5V 240-Pin Server RAM
- 8GB
- DDR3 1600 (PC3 1280…
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
A-Tech
A 16 GB dual-channel DDR3L 1333 ECC registered DIMM kit for compatible servers and workstations
Capacity 16GB (2 x 8GB)
Speed DDR3L 1333 (PC3L 10600)
This 16 GB kit contains two 8 GB DDR3L registered DIMMs built for servers and workstations that require ECC memory. Each module runs at 1333 MHz with CL9 latency and a 2Rx4 organisation. The kit is not compatible with standard desktop or laptop platforms.
Modules operate at 1.35 V and can also run at 1.5 V, reducing power draw and heat in dense memory configurations. Registered buffering lightens the electrical load on the memory controller, helping stability in multi-DIMM layouts. ECC circuitry corrects single-bit errors to protect data integrity.
The 240-pin DIMMs install in matched pairs to populate dual-channel slots on qualified server boards. Major-brand chips and full validation testing aim to deliver reliable operation under sustained workloads. Verify your system manual for supported speeds, maximum capacity and population rules before installation.
| Brand | A-Tech |
|---|---|
| Series | A-Tech DDR3 Server Memory RAM |
| Model | A-Tech 8GB 2Rx4 PC3L-10600R |
| Capacity | 16GB (2 x 8GB) |
| Speed | DDR3L 1333 (PC3L 10600) |
| CAS Latency | CL9 |
| Voltage | 1.35V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Multi-channel Kit | Dual Channel Kit |
| Chipset | Major Brand Chipset |
| Features | Major Brand Chips |
إصدارات أخرى من هذا الطراز
نفس الفئة، بذاكرة أو مبرّد أو تردد مختلف — قارن قبل أن تقرر.
Power down, open the chassis, align each module's notch with the slot key, press firmly until both latches click, then populate the correct channel pair indicated in the system manual for dual-channel operation.
No routine maintenance is required; the modules either pass POST or they do not, so replacement only occurs if a stick fails or a capacity upgrade is desired.
The 1333 MHz bus speed and CL9 latency set the throughput ceiling, so bandwidth saturates before the 1.35 V low-voltage headroom becomes a factor.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
لا توجد لغة مطابقة.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟