A-Tech 16GB DDR4 3200 ECC RDIMM 1Rx8 CL22 1.2V 288-Pin Server RAM
- 16GB
- 288-Pin DDR4 SDRAM
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
A-Tech
A 32 GB dual-channel kit of DDR4 2933 ECC registered DIMMs for servers and workstations
Capacity 32GB (2 x 16GB)
This A-Tech kit provides 32GB of DDR4 ECC registered memory across two 16GB modules. It is built for servers and workstations that require error correction and registered signalling. Desktop and laptop systems cannot use these modules.
Each module runs at the standard 1.2V DDR4 voltage without a heat spreader. The single-rank 1Rx8 organisation helps keep power draw modest under typical server workloads. No active cooling is included or required by the modules themselves.
The 288-pin DIMMs install in dual-channel pairs following the system manual’s seating guidelines. Registered buffering and ECC function only on platforms designed for DDR4 RDIMM memory. Buyers who need non-ECC or unbuffered modules for consumer boards cannot use this kit.
| Brand | A-Tech |
|---|---|
| Series | A-Tech DDR4 Server Memory RAM |
| Model | A-Tech 16GB 1Rx8 PC4-2933Y-R |
| Part Number | AT16G2D4D2933RS8N12V |
| Capacity | 32GB (2 x 16GB) |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2933 (PC4 23400) |
| CAS Latency | CL21 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 1Rx8 |
| Multi-channel Kit | Dual Channel Kit |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Features | Major Brand Chips / Error Correcting Technology for Server Systems |
إصدارات أخرى من هذا الطراز
نفس الفئة، بذاكرة أو مبرّد أو تردد مختلف — قارن قبل أن تقرر.
Power off the server, open the chassis, align each module's notch with the slot key, press down until the retention clips click, then verify in BIOS that both 16GB modules are detected at 2933 MHz.
No scheduled maintenance is required; the modules have no heat spreaders or moving parts, so replacement is only necessary if a module fails or the server's maximum supported capacity is increased.
The DDR4 2933 MT/s data rate and CL21 latency set the throughput ceiling; sustained workloads will hit that bandwidth limit before the 1.20V voltage or single-rank architecture becomes a constraint.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟