EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
A-Tech
8 GB DDR3L 1600 ECC SODIMM module with 2Rx8 organisation, CL11 latency and 1.35 V low-voltage operation
This 8GB DDR3L module runs at 1600 MHz with CL11 latency and 1.35 V operation. It uses a 204-pin SO-DIMM form factor and includes ECC error correction for data integrity. The unbuffered design fits compatible laptop or workstation slots. Major-brand chips are tested for reliable performance in demanding environments.
Buyers whose platforms require registered or fully buffered memory cannot use this unbuffered module. Systems limited to standard non-ECC DDR3 will not benefit from the error-correction feature. Laptops or servers that only support 1.5 V DDR3 may not accept the lower 1.35 V specification. Verify your hardware manual before ordering.
Installation follows the standard SO-DIMM procedure: align the notch, insert at an angle, then press down until the clips lock. The most common issue is a motherboard that rejects 1.35 V modules or disables ECC in BIOS. Confirm the system supports DDR3L and unbuffered ECC to avoid a no-post situation.
| Brand | A-Tech |
|---|---|
| Capacity | 8GB |
| Type | 204-Pin DDR3 SO-DIMM |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Voltage | 1.35V |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Features | Major Brand Chips |
| Recommend Use | AMD & Intel Compatible |
Yes — this module uses a 204-pin DDR3L SODIMM form factor and requires a compatible slot that supports 1.35 V DDR3L 1600 (PC3L-12800) operation.
The module is an unbuffered ECC DDR3L 1600 part; it will only function if the platform’s memory controller and BIOS explicitly support ECC SODIMMs.
Check the memory details in your OS or BIOS — the speed should show 1600 MHz (PC3L-12800), voltage 1.35 V, and ECC reported as enabled or active.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
No language matches that.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟