OWC 1U6T32R804GB 4GB DDR3L 1600 CL11 1.35V desktop RAM
- 4GB
- DDR3L 1600 (PC3L 12…
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
OWC
An 8 GB dual-channel DDR3 kit running at 1600 MHz with CL11 latency and 1.5 V operation for desktop upgrades
Capacity 8GB (2 x 4GB)
This kit provides eight gigabytes of DDR3 memory split across two four-gigabyte modules running at 1600 MT/s with CL11 latency at 1.5 volts. It is built for desktop and workstation boards that accept 240-pin unbuffered non-ECC DIMMs.
JEDEC-standard timings and voltage keep the modules stable during long rendering, compilation or virtual-machine sessions without throttling. The dual-channel layout doubles peak bandwidth over a single stick, so throughput stays consistent when all slots are populated.
Align the notch on each 240-pin DIMM with the motherboard key and press firmly until the retention clips click; no heat spreader means low-profile coolers clear the modules easily. The most common issue is mixing these sticks with faster or lower-latency kits, which forces the board to run at the slowest common settings.
| Brand | OWC |
|---|---|
| Part Number | 1U6D32R8008P |
| Capacity | 8GB (2 x 4GB) |
| Speed | DDR3 1600 (PC3 12800) |
| CAS Latency | CL11 |
| Voltage | 1.5V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Multi-channel Kit | Dual Channel Kit |
| Color | Black |
| Heat Spreader | No |
| Recommend Use | Desktops |
| LED Color | None |
إصدارات أخرى من هذا الطراز
نفس الفئة، بذاكرة أو مبرّد أو تردد مختلف — قارن قبل أن تقرر.
Yes, the kit uses standard 240-pin unbuffered DDR3 DIMMs rated at 1600 MHz CL11 and 1.5 V, matching the JEDEC PC3-12800 specification for desktop and workstation boards.
The modules are non-ECC, so they will work in any desktop or workstation that requires standard unbuffered DDR3 without error correction.
You can add the pair to empty slots, but for best stability all installed DIMMs should share the same speed, voltage and timing; mixing different CL values or voltages may force the system to run at the lowest common settings.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
لا توجد لغة مطابقة.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟