OWC 8GB DDR3 1600 CL11 ECC UDIMM 2Rx8 1.5V 240-pin memory upgrade
- 8GB
- 240-Pin DDR3 ECC UD…
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
OWC
8GB DDR3 1066 PC3-8500 CL7 204-pin SODIMM for NCR N3000 site controller
This 8GB DDR3 SODIMM is built specifically for the NCR POS N3000 Site Controller (1657). It provides a single-module memory increase for that platform. The module suits technicians maintaining or expanding existing point-of-sale deployments. Buyers needing a different form factor or a newer memory generation cannot use this part.
The module uses a 204-pin SO-DIMM edge connector and operates at 1.5V, matching the electrical and mechanical requirements of the target system. It runs at DDR3 1066 (PC3-8500) with CL7 latency and a 2Rx8 organisation. No heat spreader is fitted, so the module relies on chassis airflow. Systems requiring ECC, registered buffering, or a different pin count are not compatible.
The stick ships as a JEDEC-standard, RoHS-compliant component that preserves the original equipment warranty. OWC backs the module with a limited lifetime warranty and free technical support. No additional cables, brackets, or software utilities are bundled with the memory itself.
| Brand | OWC |
|---|---|
| Part Number | 8S5D32R808GB |
| Capacity | 8GB |
| Type | 204-Pin DDR3 Non-ECC SODIMM |
| Speed | DDR3 1066 (PC3 8500) |
| CAS Latency | CL7 |
| Voltage | 1.5V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Heat Spreader | No |
| Compatible System | NCR POS N3000 Site Controller (1657) |
إصدارات أخرى من هذا الطراز
نفس الفئة، بذاكرة أو مبرّد أو تردد مختلف — قارن قبل أن تقرر.
The module runs at standard JEDEC 1.5 V with CL7 latency and no heat spreader; thermal limits depend on the N3000 chassis airflow, not the DIMM itself.
The unbuffered 2Rx8 DDR3 part draws nominal 1.5 V power and has no onboard cooling; any extra heat or noise comes from the system’s own fans, not the memory.
The module is tested for the N3000 (1657) and follows JEDEC PC3-8500 specs; install it in an available 204-pin slot — no extra parts required.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
لا توجد لغة مطابقة.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟