Přijímáme kryptoměny — takže to, co držíte, můžete utratit za skutečný hardware.Plaťte kryptem, utrácejte ho za skutečný hardware. Pojištěná doprava zdarma po celém světě nad 399 $. Neutrální přepravní krabice bez loga, odesílané z Německa.Pojištěná doprava zdarma nad 399 $. Jakmile se otevře pokladna, je váš kurz zablokovaný na 30 minut.Kurz zablokovaný na 30 minut. Každý výrobek je zapečetěný, jeho sériové číslo je zkontrolované a vztahuje se na něj 24měsíční záruka.Zapečetěno, záruka 24 měsíců.

Sledované položky Přihlásit se

NEMIX RAM

NEMIX RAM ME44800-328K1 32GB DDR5 5600 ECC UDIMM memory upgrade

SKU CH-R1MT-FVENR

32 GB DDR5 5600 ECC UDIMM with CL46 latency and 1.1 V operation, validated for Supermicro X14SAE motherboards

  • Capacity32GB
  • Type288-Pin DDR5 ECC UDIMM
  • SpeedDDR5 5600 (PC5 44800)
  • CAS LatencyCL46
  • Voltage1.10V
  • ECCYes
  • 32 GB capacity handles large workloads and virtual machines
  • DDR5 5600 speed transfers data at up to 5600 MT/s
  • ECC protection detects and corrects single-bit errors automatically
  • 1 V operation reduces power draw and heat output
  • 288-pin UDIMM form factor fits Supermicro X14SAE motherboard

Exact-match upgrade for Supermicro X14SAE

This 32 GB DDR5-5600 ECC UDIMM module is built to the precise rank, voltage and timing the Supermicro X14SAE motherboard expects. It installs as a single 288-pin unbuffered DIMM running at 1.1 V with CL46 latency, delivering 32 GB of error-correcting memory that the board recognises at full rated speed.

Who this suits and who should look elsewhere

Builders upgrading a Supermicro X14SAE system that requires DDR5-5600 ECC UDIMM modules will find the correct form factor and specification here. Buyers whose platforms need registered RDIMMs, SODIMMs, non-ECC memory or a different DDR generation cannot use this kit.

Installation notes

The module seats in a standard 288-pin DDR5 UDIMM slot; align the notch and press firmly until the retention clips click. Common issues include mixing this unbuffered ECC stick with registered DIMMs, populating slots in an order the motherboard manual forbids, or forgetting to enable ECC in the BIOS after installation.

Přednosti

  • 32 GB capacity handles large workloads and virtual machines
  • DDR5 5600 speed transfers data at up to 5600 MT/s
  • ECC protection detects and corrects single-bit errors automatically
  • 1 V operation reduces power draw and heat output
  • 288-pin UDIMM form factor fits Supermicro X14SAE motherboard

Specifikace

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 ECC Unbuffered UDIMM Memory
Part NumberME44800-328K1
Capacity32GB
Type288-Pin DDR5 ECC UDIMM
SpeedDDR5 5600 (PC5 44800)
CAS LatencyCL46
Voltage1.10V
ECCYes
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR5 ECC Unbuffered UDIMM Motherboard Compatible
Package Content32GB DDR5 5600MHz PC5-44800 2Rx8 1.1V 288-PIN ECC UDIMM KIT

Další verze tohoto modelu

Dalších 5 v této řadě

Stejná řada, jiná paměť, chladič nebo takt — porovnejte, než se rozhodnete.

Otázky k tomuto produktu

Does my Supermicro X14SAE motherboard need a specific DIMM population order for this 32GB DDR5 5600 ECC UDIMM?

Yes, the board's manual lists supported capacities and the required installation sequence; follow that order so the memory controller recognises the full 32 GB at 5600 MT/s.

Can I install this 2Rx8 DDR5 5600 ECC UDIMM in a slot that currently holds a 1Rx8 DDR5 4800 module?

Mixing ranks and speeds forces the memory controller to run all DIMMs at the lowest common speed and may disable ECC; use identical 2Rx8 5600 modules for full rated performance.

How do I verify the kit is running at DDR5 5600 with ECC active after installation?

Enter the BIOS or run a hardware-information utility and confirm the reported speed shows 5600 MT/s, CL46 timings, 1.1 V and that ECC status reads enabled.

Také v této kategorii

Zákazníci také porovnávali

Stejná kategorie, stejná pokladna — osm měn a kurz zamčený na 30 minut.