Systor SYSNVME-YL03REG09 1-to-9 M.2 NVMe/SATA Duplicator 18GB/min

Standalone M.2 Duplicator for High-Volume Cloning

The Systor SYSNVME-YL03REG09 duplicates one source drive to up to nine targets without a host PC. It accepts M.2 modules in 2230, 2242, 2260 and 2280 form factors using B key, M key or B+M key interfaces. Optional adapters extend support to 2.5 inch and 3.5 inch SATA drives. The unit operates completely standalone with a single-button start.

Transfer Rate and Interface Constraints

Maximum throughput is 300 MB/s, which translates to roughly 18 GB per minute under ideal drive conditions. Actual speed depends on the read and write limits of the specific source and target media installed. The duplicator handles NVMe and SATA protocols on the M.2 slots but cannot exceed the bandwidth of the slowest drive in a session. Proprietary or unknown filesystem formats are copied sector-by-sector.

Replaces Manual PC-Based Imaging Workflows

This device removes the need to tie up workstations or write custom scripts for mass deployment or sanitisation. It adds value when you regularly clone three or more drives per job and want consistent speed without degradation across all nine ports. Daisy-chaining multiple units lets you scale beyond nine targets. It is not suited for users who only occasionally duplicate a single drive or who require network-attached operation.