SPARTAN 1-to-9 SATA HDD/SSD Duplicator H09HSHEB
- Hard Drive Duplicat…
- 1 to 9
Aceptamos criptomonedas — así, las criptos que usted tiene pueden comprar hardware real.Pague en cripto y gástela en hardware real. Envío asegurado gratis a nivel mundial a partir de $399. Cajas neutras, sin marca, enviadas desde Alemania.Envío asegurado gratis a partir de $399. Su cotización queda bloqueada 30 minutos en cuanto se abre el pago.Cotización bloqueada 30 minutos. Todos los artículos vienen sellados, con el número de serie verificado y cubiertos por una garantía de 24 meses.Sellado, con 24 meses de garantía.
IBM
A 2 TB, 7200 RPM SATA 3.0 Gb/s desktop drive with dual-port hot-swap tray for IBM Xseries storage
The IBM 59Y5484 is a 2TB 3.5 inch internal hard drive that spins at 7200 RPM over a SATA 3.0Gb/s link. It arrives new with a hot-swap tray for direct insertion into compatible IBM Xseries storage enclosures. System builders who need a single high-capacity spindle for bulk data will find the form factor familiar and the interface widely supported.
This drive replaces an older 3.5 inch SATA disk of lower capacity or slower spindle speed when the storage array has a free hot-swap bay. The jump is worth it when the workload demands more terabytes at 7200 RPM without changing cabling or controller firmware. Buyers who need a different interface or a smaller form factor cannot use this unit.
Under continuous read or write loads the spindle maintains 7200 RPM and the SATA 3.0Gb/s link delivers steady throughput limited by the mechanical media. The dual-port design provides path redundancy inside supported enclosures so a single controller failure does not halt access. Workloads that require solid-state latency or higher interface bandwidth will not be satisfied by this drive.
| Brand | IBM |
|---|---|
| Interface | SATA 3.0Gb/s |
| Capacity | 2TB |
| RPM | 7200 RPM |
| Form Factor | 3.5" |
The supplied hot-swap tray fits a standard 3.5-inch bay; the drive itself measures 8.7 height, 3.5 width and 1 length in the same units.
Both SATA ports on the tray backplane must be seated; connecting only one port leaves the second path inactive and can cause the array to report a degraded path.
Replace the tray if the latch mechanism no longer locks securely or if either backplane SATA connector shows bent pins or intermittent contact during drive swaps.
También en este pasillo
Mismo estante, mismo pago — ocho criptomonedas y un tipo de cambio fijado 30 minutos.
Lo que usted paga, y la moneda en la que lee los precios.
Se envía desde su billetera al finalizar la compra
Solo informativo — el catálogo está en dólares
Ninguna moneda coincide.
Elija el idioma en el que el sitio le habla.
Ningún idioma coincide.
¿Es nuevo aquí?
¿Ya tiene una?
No existe ningún restablecimiento automático: esta tienda no envía correos electrónicos, así que no hay ningún enlace de un solo uso que solicitar. Deje la dirección asociada a la cuenta y se atenderá de forma manual.
Solicitud registrada
No hay nada de camino a su bandeja de entrada: esta tienda no envía correos en absoluto. Alguien se encarga de esto manualmente.
¿La recordó?