SPARTAN 1-to-9 SATA HDD/SSD Duplicator H09HSHEB
- Hard Drive Duplicat…
- 1 to 9
Aceitamos criptomoeda — para que as moedas que detém possam comprar material informático real.Pague em cripto, gaste-a em material informático real. Envio seguro gratuito para todo o mundo acima de 399 $. Caixas neutras, sem marca, expedidas a partir da Alemanha.Envio seguro gratuito acima de 399 $. A sua taxa fica bloqueada durante 30 minutos assim que abre a finalização da compra.Taxa bloqueada 30 minutos. Cada artigo é selado, o seu número de série é verificado, e está coberto por uma garantia de 24 meses.Selado, garantido 24 meses.
IBM
A 2 TB, 7200 RPM SATA 3.0 Gb/s desktop drive with dual-port hot-swap tray for IBM Xseries storage
The IBM 59Y5484 is a 2TB 3.5 inch internal hard drive that spins at 7200 RPM over a SATA 3.0Gb/s link. It arrives new with a hot-swap tray for direct insertion into compatible IBM Xseries storage enclosures. System builders who need a single high-capacity spindle for bulk data will find the form factor familiar and the interface widely supported.
This drive replaces an older 3.5 inch SATA disk of lower capacity or slower spindle speed when the storage array has a free hot-swap bay. The jump is worth it when the workload demands more terabytes at 7200 RPM without changing cabling or controller firmware. Buyers who need a different interface or a smaller form factor cannot use this unit.
Under continuous read or write loads the spindle maintains 7200 RPM and the SATA 3.0Gb/s link delivers steady throughput limited by the mechanical media. The dual-port design provides path redundancy inside supported enclosures so a single controller failure does not halt access. Workloads that require solid-state latency or higher interface bandwidth will not be satisfied by this drive.
| Brand | IBM |
|---|---|
| Interface | SATA 3.0Gb/s |
| Capacity | 2TB |
| RPM | 7200 RPM |
| Form Factor | 3.5" |
The supplied hot-swap tray fits a standard 3.5-inch bay; the drive itself measures 8.7 height, 3.5 width and 1 length in the same units.
Both SATA ports on the tray backplane must be seated; connecting only one port leaves the second path inactive and can cause the array to report a degraded path.
Replace the tray if the latch mechanism no longer locks securely or if either backplane SATA connector shows bent pins or intermittent contact during drive swaps.
Também nesta secção
Mesma prateleira, mesma finalização da compra — oito moedas e uma taxa bloqueada durante 30 minutos.
O que paga, e a moeda em que vê os preços.
Enviado da sua carteira ao finalizar a compra
Apenas informativo — o catálogo está em dólares
Nenhuma moeda corresponde.
Escolha o idioma em que o site lhe fala.
Nenhum idioma corresponde.
Ainda não tem conta?
Já tem conta?
Não existe reposição automática: esta loja não envia qualquer e-mail, pelo que não há nenhum link de utilização única para pedir. Deixe o endereço na conta e ele será tratado manualmente.
Pedido registado
Não vai chegar nada à sua caixa de entrada — esta loja não envia qualquer e-mail. Alguém trata disto manualmente.
Recordou-se dela?