myVolts 6× ATX 30 cm 24-pin dual PSU extension cable

Dual PSU splitter for mining rigs

This cable splits a single motherboard 24-pin connector into two 24-pin female ends so a second power supply can be started in sync. It lets builders run multiple graphics cards or drives from one board without buying another motherboard. Each lead is 30 cm long and rated for a combined draw of 2000 W. The pack contains six identical cables for multi-GPU rigs.

Suits builders adding a second PSU to an existing

It works with both 20-pin and 24-pin ATX motherboards and any pair of standard ATX units. The synchronous start signal turns both supplies on and off together. Systems that need fully isolated rails or independent PSU control cannot use this adapter. Buyers whose cases lack physical space for two power supplies should look at something else.

Handles up to 2000 W across both supplies

The 24-pin male plug feeds the motherboard while the two female sockets accept the PSU cables. Power from the first supply should stay on the board; the second supply should only feed drives or peripheral devices. Mixing outputs between the two units is not supported. The 30 cm length gives enough reach for typical chassis layouts without excess slack.