Aceptamos criptomonedas — así, las criptos que usted tiene pueden comprar hardware real.Pague en cripto y gástela en hardware real. Envío asegurado gratis a nivel mundial a partir de $399. Cajas neutras, sin marca, enviadas desde Alemania.Envío asegurado gratis a partir de $399. Su cotización queda bloqueada 30 minutos en cuanto se abre el pago.Cotización bloqueada 30 minutos. Todos los artículos vienen sellados, con el número de serie verificado y cubiertos por una garantía de 24 meses.Sellado, con 24 meses de garantía.

Artículos guardados Iniciar sesión
Two green 288-pin DDR4 RDIMM modules in static bags

OWC

OWC 64GB (2x32GB) DDR4 2666 CL19 ECC Registered RDIMM memory upgrade

SKU CH-F7QD-94G3Y

64GB dual-channel DDR4-2666 ECC registered RDIMM kit for Synology ActiveProtect DP7200 and DP7400

  • Capacity64GB (2 x 32GB)
  • Type288-Pin DDR4 ECC RDIMM
  • SpeedDDR4 2666 (PC4 21300)
  • CAS Latency19
  • Voltage1.2V
  • ECCYes

Capacity 64GB (2 x 32GB)

  • ECC registered design prevents data corruption in servers
  • 64GB kit with two 32GB modules expands memory capacity
  • DDR4 2666 speed with CL19 latency delivers responsive performance
  • 2V low voltage reduces power draw in compatible systems
  • Validated for Synology ActiveProtect DP7200 and DP7400 appliances

Capacity and Form Factor

This OWC kit provides 64GB of DDR4 memory in two 32GB registered DIMMs. Each module uses a 288-pin layout and runs at 1.2V with a CL19 latency rating. The 2Rx4 organisation and ECC registered design target server and workstation platforms.

Suited Systems and Limitations

The modules are validated for Synology ActiveProtect DP7200 and DP7400 appliances. They also operate in systems rated for 2133MHz or 2400MHz DDR4. Standard desktop computers cannot use registered ECC memory, and mixing these sticks with unbuffered or load-reduced DIMMs is not supported.

Decisive Specification

The registered ECC attribute is the single factor that decides compatibility. Only platforms designed for registered DDR4 ECC RDIMMs will accept this kit; consumer motherboards and unbuffered server boards will not.

Puntos fuertes

  • ECC registered design prevents data corruption in servers
  • 64GB kit with two 32GB modules expands memory capacity
  • DDR4 2666 speed with CL19 latency delivers responsive performance
  • 2V low voltage reduces power draw in compatible systems
  • Validated for Synology ActiveProtect DP7200 and DP7400 appliances

Especificaciones

BrandOWC
Part Number2R6D42R4064P
Capacity64GB (2 x 32GB)
Type288-Pin DDR4 ECC RDIMM
SpeedDDR4 2666 (PC4 21300)
CAS Latency19
Voltage1.2V
ECCYes
Buffered/RegisteredRegistered
Rank2Rx4
Heat SpreaderNo
Compatible SystemSynology ActiveProtect DP7200
Synology ActiveProtect DP7400

Otras versiones de este modelo

3 más en esta gama

Misma familia, con memoria, disipador o frecuencia diferentes — compare antes de decidirse.

Preguntas sobre este artículo

Does the 288-pin DDR4 RDIMM fit the memory slots on the Synology ActiveProtect DP7200 and DP7400?

Yes, the 288-pin DDR4 2666 registered DIMM is built to the JEDEC standard for those models and installs directly into their RDIMM slots.

What is the correct way to seat both 32 GB modules so the system recognises the full 64 GB?

Power off the unit, open the chassis, align each module's notch with the slot key, press firmly until both side clips click, then power on and verify 64 GB in the Synology DSM memory report.

When should the ECC registered modules be replaced to keep the NAS running reliably?

Replace them if DSM reports correctable ECC errors that climb over time, if the system fails memory self-test at boot, or after a confirmed DIMM fault in the hardware log.

También en este pasillo

Los clientes también compararon

Mismo estante, mismo pago — ocho criptomonedas y un tipo de cambio fijado 30 minutos.