EN-Labs 11-001-366 PCIe x4 USB 3.2 10Gbps 5-port card
- no
- 12CM Case fan,screw…
A-Tech
ECC registered DDR3 DIMM with 8 GB capacity, 1600 MHz speed and CL11 latency for server workloads
This 8GB DDR3 module runs at 1600MHz with CL11 latency and 1.5V operation. It uses a 240-pin DIMM form factor and features ECC registered 2Rx8 architecture for server reliability.
Systems that require unbuffered non-ECC DDR3 or a different DDR generation cannot use this module. Buyers without a compatible 240-pin registered memory slot should look elsewhere.
The module is a registered ECC DIMM with 2Rx8 organisation, so the motherboard must support registered error-correcting memory. Verify your platform accepts this exact configuration before ordering.
| Brand | A-Tech |
|---|---|
| Capacity | 8GB |
| Speed | DDR3 1600 (PC3 12800) |
| CAS Latency | CL11 |
| Voltage | 1.50V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Features | Major Brand Chips |
Power off the server, open the chassis, align the notch on the 240-pin module with the slot key, press firmly until both retention clips click, then power on and verify the full 8 GB appears in BIOS or system firmware.
No routine maintenance is required; the module either continues operating or develops correctable/uncorrectable errors that the platform logs, at which point the 8 GB stick is replaced as a unit.
The memory controller's maximum supported frequency and voltage ceiling — 1600 MT/s at 1.50 V — caps throughput before the module's own timing or thermal limits are reached.
同じ売り場の商品
同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。
お支払いに使うコインと、価格表示に使う通貨です。
チェックアウト時にウォレットから送信されます。
表示のみ—カタログの価格は米ドル建てです。
該当する通貨がありません。
サイトの表示言語を選択してください。
初めてのご利用ですか?
すでにお持ちですか?
自動的な再設定はありません。当店はメールを送信しないため、ワンタイムリンクをお送りすることもできません。アカウントにメールアドレスを残しておいていただければ、担当者が手作業で確認いたします。
リクエストを受け付けました
受信箱に何かが届くことはありません — 当店はメールを一切送信していません。担当者が手作業で確認いたします。
思い出しましたか?