暗号資産でのお支払いに対応—お手持ちのコインで、本物のハードウェアをご購入いただけます。暗号資産で支払い、本物のハードウェアに使う。 $399以上のご注文で、世界中どこでも送料無料（保険付き）。無地・ノーブランドの外箱で、ドイツから発送いたします。$399以上で送料無料（保険付き）。 注文手続きを開始すると、レートは30分間ロックされます。レートは30分間ロック。 すべての商品は未開封で、シリアル番号を確認した上で、24か月保証が付いています。未開封、24か月保証。

ウォッチリスト ログイン
Four green DDR4 RDIMM modules without heat spreaders in a kit

NEMIX RAM

NEMIX RAM 1TB (4x256GB) DDR4 3200 CL22 8Rx4 ECC Registered RDIMM memory upgrade

SKU CH-C46Z-NG6C9

A 1 TB server memory kit with four 256 GB DDR4 3200 CL22 registered ECC RDIMMs for Supermicro X12DPL-NT6 and X12DPL-i6 motherboards

  • Capacity1TB (4 x 256GB)
  • Type288-Pin DDR4 RDIMM
  • SpeedDDR4 3200 (PC4 25600)
  • CAS LatencyCL22
  • Voltage1.20V
  • ECCYes

Size 1TB 4X256GB

  • 1TB capacity in a matched 4 × 256 GB kit for maximum server density
  • DDR4 3200 MT/s speed with CL22 latency runs at rated throughput
  • Registered ECC RDIMM design offloads the controller and corrects single-bit errors
  • 8Rx4 organisation and 1.2 V operation match the motherboard memory-controller requirements
  • 288-pin form factor validated for Supermicro X12DPL-NT6 and X12DPL-i6 boards

1TB DDR4-3200 8Rx4 Registered ECC Kit

This 1TB kit contains four 256GB DDR4-3200 (PC4-25600) Registered ECC RDIMMs rated CL22 at 1.20V. The modules use a 288-pin form factor and an 8Rx4 organisation built with major-brand Samsung, Micron or Hynix DRAM. They are qualified for Supermicro X12DPL-NT6 and X12DPL-i6 motherboards that require registered memory.

Suited for servers needing maximum registered

This kit suits administrators populating every slot of a compatible Supermicro X12DPL board with the highest-density registered ECC modules the platform accepts. It is not for systems that only accept unbuffered UDIMMs, SODIMM form factors, lower-density ranks, or speeds other than DDR4-3200.

8Rx4 rank organisation decides compatibility

The 8Rx4 rank structure is the single specification the memory controller checks before recognising each 256GB module at full capacity. If the motherboard's qualified-vendor list does not explicitly approve 8Rx4 Registered DIMMs, the system will not boot or will see reduced capacity.

特長

  • 1TB capacity in a matched 4 × 256 GB kit for maximum server density
  • DDR4 3200 MT/s speed with CL22 latency runs at rated throughput
  • Registered ECC RDIMM design offloads the controller and corrects single-bit errors
  • 8Rx4 organisation and 1.2 V operation match the motherboard memory-controller requirements
  • 288-pin form factor validated for Supermicro X12DPL-NT6 and X12DPL-i6 boards

仕様

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Server Memory
ModelDDR4 ECC RDIMM Registered Server Memory
Part NumberMR25600-2584K4
Capacity1TB (4 x 256GB)
Type288-Pin DDR4 RDIMM
SpeedDDR4 3200 (PC4 25600)
CAS LatencyCL22
Voltage1.20V
ECCYes
Buffered/RegisteredRegistered
Rank8Rx4
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
Compatible SystemSupermicro
FeaturesDDR4 ECC RDIMM Motherboard Compatible
Package Content1TB 4X256GB DDR4 3200MHz PC4-25600 8Rx4 1.2V 288-PIN ECC RDIMM KIT

このモデルの他のバージョン

同シリーズにさらに 3点

同じファミリーで、メモリ・クーラー・クロックが異なります — 購入前に比較してください。

この商品に関する質問

What motherboard and CPU combination must I already have for this 1TB DDR4-3200 8Rx4 RDIMM kit to be recognised at full capacity?

This kit is verified for Supermicro X12DPL-NT6 and X12DPL-i6 motherboards running DDR4 3200 PC4-25600; the board must support 288-pin registered ECC modules and 8Rx4 population rules.

If I keep older DDR4 RDIMMs in the same server, will this 8Rx4 1.2 V CL22 kit run alongside them without down-clocking?

Mixing ranks or speeds forces the memory controller to run all slots at the lowest common speed and timing; for stable full-speed operation populate every channel with identical 8Rx4 modules.

After installation, how can I confirm the server sees all 1 TB at DDR4 3200 CL22 with ECC active?

Check the BIOS memory information screen or run dmidecode — it should report four 256 GB DDR4 3200 registered ECC DIMMs at 1.2 V, CAS 22, total 1 TB.

同じ売り場の商品

よく比較されている商品

同じ売り場、同じレジ — 8種類のコインと30分間のレートロック。