NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
A-Tech
A 32 GB DDR5 laptop module running at 4800 MHz with CL40 latency and 1.1 V operation
This 32GB module uses DDR5 technology at 4800MHz with CL40 latency and runs at the standard 1.10V. It fits laptop, notebook, and all-in-one systems that accept 262-pin SO-DIMM memory. The unbuffered, non-ECC design matches mainstream mobile platforms.
The module is a compatible replacement for Corsair CMSX64GX5M2A4800C40 and CMSX32GX5M1A4800C40 kits. Builders moving from lower-capacity or slower DDR5 SODIMMs gain a direct drop-in upgrade. The jump is worth it when the system supports 4800MHz operation and the single 32GB stick meets the desired total capacity.
The bare circuit board slides into tight laptop chassis where taller modules cannot fit. Running at 1.10V keeps power draw low for mobile thermal envelopes. Buyers who need ECC error correction, registered buffering, or a second module to reach 64GB should look elsewhere.
| Brand | A-Tech |
|---|---|
| Series | Compatible Replacement for Corsair |
| Model | CMSX64GX5M2A4800C40, CMSX32GX5M1A4800C40 |
| Capacity | 32GB |
| Type | 262-Pin DDR5 SO-DIMM |
| Speed | DDR5 4800 (PC5 38400) |
| CAS Latency | CL40 |
| Voltage | 1.10V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Heat Spreader | No |
| Features | CMSX64GX5M2A4800C40, CMSX32GX5M1A4800C40 |
| Recommend Use | Compatible Replacement for Corsair CMSX64GX5M2A4800C40, CMSX32GX5M1A4800C40 |
The module uses the standard 262-pin DDR5 SO-DIMM form factor, which matches any laptop slot built for DDR5 SO-DIMMs.
Align the notch on the gold edge with the key in the slot, press the stick straight in until the gold fingers are fully hidden, then push down until both side clips snap into the module notches.
No firmware or thermal-pad maintenance is required; the unbuffered non-ECC module runs at standard 1.10V DDR5 voltage for its service life.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?