We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Red gold silk PLA filament spool 1.75mm

BFKK

BFKK 1.75mm Silk PLA Filament Red Gold Dual Color 1kg

SKU CH-7AWP-ZP1NJ

Dual-colour 1.75 mm silk PLA filament on a 1 kg spool prints pearlescent red-gold surfaces without polishing

  • Silk-like pearlescent finish without polishing
  • Dual-colour coextrusion prints two shades in one spool
  • 75 mm diameter tolerance ensures consistent feeding
  • Compatible with most FDM printers and 3D pens
  • 100 % tangle-free on the spool

Silk PLA for multi-colour prints

BFKK 1.75 mm Silk PLA filament combines two colours in a single strand so one spool produces prints with a red-gold gradient. The co-extruded material is aimed at makers who want pearlescent surfaces without post-processing and who print on common FDM machines or 3D pens.

Low-odour feed with tight tolerance

The filament holds a 1.75 mm diameter tolerance that promotes consistent feeding and reduces jams or warping during normal use. Low odour and bubble-free extrusion keep the printing environment pleasant while the silk-like finish emerges straight from the nozzle.

Nozzle guidance and tangle prevention

A fresh 0.4 mm or larger nozzle is recommended to realise the best surface quality from the silk formulation. Each spool ships 100 % tangle-free; securing the free end in the spool holes after every print prevents knots and ensures reliable feeding for the next session.

Highlights

  • Silk-like pearlescent finish without polishing
  • Dual-colour coextrusion prints two shades in one spool
  • 75 mm diameter tolerance ensures consistent feeding
  • Compatible with most FDM printers and 3D pens
  • 100 % tangle-free on the spool

Specifications

No published specifications for this item yet.

Questions about this item

How do I load the 1.75mm Silk PLA onto my FDM printer without the first layer failing?

Mount the spool so filament unwinds counter-clockwise, push the tip straight through the PTFE tube into the hot-end, and extrude until the dual red-gold colour flows cleanly; the step most people skip is seating the filament fully against the nozzle before starting the print.

What upkeep does the 1 kg spool need after it is opened?

After every print, clip the free end into the spool’s side holes to keep the factory 100 % tangle-free state; store the coil in a sealed bag with desiccant because PLA absorbs moisture and will bubble or jam on the next run.

What is the first limitation I will hit when printing long jobs with this Silk PLA?

The 1.75 mm diameter tolerance and silk additive mean heat builds up in the melt zone; on extended prints the filament can soften inside the PTFE tube and cause a jam, so watch for under-extrusion as the earliest sign.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.