We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Rectangular aluminium power supply, 6.85 by 1.98 by 0.43 inches, IP67 rated, with short input and output cables

BONAEVER

BONAEVER 250W 12V 20.83A IP67 Waterproof LED Power Supply

SKU CH-05N7-AT1YE

Delivers 12V DC at 20.83A with IP67 waterproof protection and automatic safety recovery for outdoor LED lighting

  • TypePower Supply
  • Delivers 250 W at 12 V for demanding LED installations
  • IP67 rating protects against dust and water ingress outdoors
  • Built-in short-circuit, overload, over-voltage, over-current and over-temperature safeguards with auto-recovery
  • Operates from −40 °C to 40 °C for extreme climates
  • ≥85 % efficiency reduces heat and energy waste

250W 12V IP67 LED Driver

The BONAEVER unit delivers 250 watts at 12 volts DC with a 20.83 amp maximum current. It accepts an AC input between 90 and 150 volts at 47 to 63 hertz. The housing meets IP67 for dust and water protection and operates from -40 to 40 degrees Celsius. Efficiency is rated at 85 percent or higher.

Outdoor lighting installers and sign makers

This supply suits projects that need a rugged 12V source in exposed locations such as building facades, bridge railings, plazas or advertising structures. It is not intended for indoor-only desktop PC builds or for loads that require a different output voltage or a higher power rating than 250 watts.

Fits 12V LED strips, bulbs and modules

The 3.3 foot input lead and 8.66 inch output lead connect directly to mains wiring and low-voltage lighting runs. Free-air cooling and the sealed enclosure remove the need for a separate ventilated cabinet. Automatic protection against short circuit, overload, over-voltage, over-current and over-temperature resets itself once the fault clears.

Highlights

  • Delivers 250 W at 12 V for demanding LED installations
  • IP67 rating protects against dust and water ingress outdoors
  • Built-in short-circuit, overload, over-voltage, over-current and over-temperature safeguards with auto-recovery
  • Operates from −40 °C to 40 °C for extreme climates
  • ≥85 % efficiency reduces heat and energy waste

Specifications

TypePower Supply

Questions about this item

What input voltage and frequency range must my mains supply provide for this 250 W driver to operate?

The driver accepts AC 90-150 V at 47-63 Hz, matching common residential mains worldwide.

Will the IP67 rating protect the unit if I mount it alongside older non-waterproof 12 V LED strips?

Yes, the IP67 enclosure seals against dust and temporary immersion, so the driver stays protected even if adjacent strips lack waterproofing.

How can I verify the supply is delivering the rated 12 V 20.83 A after installation?

Measure the output cables with a multimeter under load; a steady 12 V DC reading confirms the driver is operating within its 250 W specification.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.