Computer Memory Solutions
Computer Memory Solutions 32GB (2x16GB) DDR4 2666MHz CL19 SODIMM memory upgrade
A 32GB kit of two 16GB DDR4 2666MHz CL19 SODIMM modules for Dell OptiPlex 3070, 5070, 7070 Micro and 7470 All-in-One systems
- Capacity32GB (2 x 16GB)
- Type260-Pin DDR4 SO-DIMM
- SpeedDDR4 2666 (PC4 21300)
- CAS LatencyCL19
- Timing19-19-19
- Voltage1.2V
- 32 GB total capacity from two 16 GB modules for heavy multitasking
- 2666 MHz DDR4 speed rated at PC4 21300 for responsive performance
- CL19 19-19-19 timings at 1.2 V for stable operation
- 260-pin SODIMM form factor fits Dell OptiPlex 3070, 5070, 7070 Micro and 7470 AIO
- Lifetime exchange or repair warranty from Computer Memory Solutions
Dell OptiPlex Micro & All-in-One Upgrade
This 32 GB kit contains two 16 GB DDR4 SO-DIMMs rated at 2666 MHz with CL19 timing. It targets Dell OptiPlex 3070 Micro, 5070 Micro, 7070 Micro and 7470 All-in-One systems that accept 260-pin unbuffered non-ECC memory. The modules run at 1.2 V and use a 2Rx8 organisation.
Replacing Slower or Smaller Factory Modules
The kit fills both SO-DIMM slots to reach the platform maximum of 32 GB. A 64-bit operating system is required to address more than 4 GB. Installing matched pairs lets the memory controller run in dual-channel mode. If existing modules remain, all memory will operate at the speed of the slowest installed stick or the processor limit.
DDR4 SO-DIMM Platform Limits
The 260-pin DDR4 interface caps transfer rates at the JEDEC standard speeds supported by the CPU and chipset. No heat spreader is fitted, so airflow in the compact Micro or All-in-One chassis determines thermal headroom. ECC and registered modules are not supported on these platforms.
Highlights
- 32 GB total capacity from two 16 GB modules for heavy multitasking
- 2666 MHz DDR4 speed rated at PC4 21300 for responsive performance
- CL19 19-19-19 timings at 1.2 V for stable operation
- 260-pin SODIMM form factor fits Dell OptiPlex 3070, 5070, 7070 Micro and 7470 AIO
- Lifetime exchange or repair warranty from Computer Memory Solutions
Specifications
| Brand | Computer Memory Solutions |
|---|---|
| Model | CM2048642666SO |
| Capacity | 32GB (2 x 16GB) |
| Type | 260-Pin DDR4 SO-DIMM |
| Speed | DDR4 2666 (PC4 21300) |
| CAS Latency | CL19 |
| Timing | 19-19-19 |
| Voltage | 1.2V |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Rank | 2Rx8 |
| Chipset | Major Brand Chipset |
| Heat Spreader | No |
| Compatible System | Dell OptiPlex 3070 Micro, OptiPlex 5070 Micro (MFF), OptiPlex 7070 Micro (MFF), OptiPlex 7470 All-in-One |
| Package Content | 2 Memory RAM Sticks |
Questions about this item
Will the 260-pin SODIMM modules fit the two memory slots in my OptiPlex 7070 Micro?
Yes, each 16 GB stick uses the standard 260-pin DDR4 SODIMM form factor that matches the two SO-DIMM sockets in the 7070 Micro, 5070 Micro, 3070 Micro and 7470 All-in-One.
What is the correct way to seat both 16 GB sticks so the system recognises the full 32 GB?
Insert each module at a 30-degree angle until the gold contacts disappear, then press down firmly until both side clips click; install the pair in the two slots to run in dual-channel mode.
When should I consider replacing these CL19 2666 MHz modules?
Replace them only if a memory test reports errors or the system becomes unstable; otherwise the non-ECC unbuffered DDR4 sticks have no wear-out mechanism and carry a limited lifetime warranty from the manufacturer.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



