Seagate
Seagate Cheetah NS ST3400755SSProduct 400 GB 3.5" SAS internal hard drive
- SLC
$23.99
0.00030606BTC
In stock
DELL
DELL Constellation ES.3 ST4000NM0033 4TB 7200RPM 128MB 3.5" SATA internal hard drive
A 4 TB 3.5" SATA internal hard drive spinning at 7200 RPM with a 128 MB cache
- 4 TB capacity stores large media libraries
- 7200 RPM spindle speed accelerates data access
- 128 MB cache buffers frequent read and write operations
- SATA 6 Gb/s interface enables fast host transfers
- 5 inch form factor fits standard desktop bays
Dell Constellation ES.3 4TB SATA Drive
This is a 3.5 inch internal hard drive with a 4TB capacity, 7200RPM spindle speed and a 128MB cache. It connects via a SATA 6Gb/s interface and is supplied in new condition. The drive is designed for desktop systems requiring high-capacity bulk storage.
Suits builds needing large mechanical storage
Buyers who want silent operation or the low access latency of solid-state media should look elsewhere. Systems limited to a 2.5 inch drive bay cannot accommodate this 3.5 inch form factor. Workloads demanding sustained transfer rates beyond the SATA 6Gb/s link will not be satisfied by this drive.
Deciding specification: 4TB capacity
The four terabyte capacity is the single figure that determines whether this drive meets the storage requirement. If the project needs more raw space, a higher-capacity drive is required. If less space is needed, a smaller drive may reduce cost and power draw. The 7200RPM speed and 128MB cache support the capacity but do not replace it as the primary filter.
Highlights
- 4 TB capacity stores large media libraries
- 7200 RPM spindle speed accelerates data access
- 128 MB cache buffers frequent read and write operations
- SATA 6 Gb/s interface enables fast host transfers
- 5 inch form factor fits standard desktop bays
Specifications
No published specifications for this item yet.
Questions about this item
Does the 3.5-inch form factor fit a standard desktop drive bay?
Yes, the 3.5-inch SATA drive mounts in any standard desktop 3.5-inch bay using four side screws or a tool-less caddy.
What is the correct order for connecting the SATA data and power cables during installation?
Attach the SATA data cable to the motherboard and drive first, then connect the SATA power cable from the power supply to the drive.
How often should I run a surface scan on the 4TB platters to catch early sector errors?
Schedule a full surface scan every three to six months; the drive’s SMART attributes will also flag reallocated sectors automatically.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
