Seagate
Seagate Cheetah NS ST3400755SSProduct 400 GB 3.5" SAS internal hard drive
- SLC
$23.99
0.00030554BTC
In stock
HPE
HPE MB4000GVYZK 4TB SATA 6.0Gb/s 7200 RPM 3.5" internal hard drive
A 4 TB SATA 6.0 Gb/s 7200 RPM 3.5" internal hard drive with digitally signed firmware and included tray
- InterfaceSATA 6.0Gb/s
- Capacity4TB
- RPM7200 RPM
- Form Factor3.5"
- 4 TB capacity stores large data sets
- 7200 RPM spindle delivers responsive throughput
- SATA 6.0 Gb/s interface enables fast transfers
- 5 inch form factor fits standard drive bays
- Digitally signed firmware protects drive integrity
4 TB SATA hard drive
The HPE MB4000GVYZK is a 4TB 3.5 inch internal hard drive built for desktop systems. It spins at 7200 RPM and connects through a SATA 6.0Gb/s interface. Digitally signed firmware helps protect data integrity during operation. The drive ships with a tray for standard large-form-factor bays.
Suited for bulk storage, not speed
This drive suits users who need affordable terabytes for backups, media libraries or archival workloads. The 7.2K spindle speed delivers steady sequential throughput for large files. Buyers who want low latency for operating systems or databases should look at solid-state alternatives. Systems limited to SATA 3.0Gb/s will not reach the interface ceiling.
SATA 6.0Gb/s interface decides fit
The single specification that decides compatibility is the SATA 6.0Gb/s interface. Your motherboard or controller must support this link speed to obtain the rated transfer rate. A 3.5 inch drive bay and a standard SATA power connector are also required. Verify both before purchase.
Highlights
- 4 TB capacity stores large data sets
- 7200 RPM spindle delivers responsive throughput
- SATA 6.0 Gb/s interface enables fast transfers
- 5 inch form factor fits standard drive bays
- Digitally signed firmware protects drive integrity
Specifications
| Brand | HPE |
|---|---|
| Model | MB4000GVYZK |
| Interface | SATA 6.0Gb/s |
| Capacity | 4TB |
| RPM | 7200 RPM |
| Form Factor | 3.5" |
Questions about this item
Do I need a SATA 6.0 Gb/s port and a 3.5-inch drive bay with an SC tray slot to install this 4 TB HPE drive?
Yes — the drive connects over a SATA 6.0 Gb/s interface and fits a standard 3.5-inch bay using the supplied SC tray, so both the port and the bay must match.
Will this 7200 RPM SATA drive share a controller with an older SATA 3.0 Gb/s drive without slowing the new drive?
The controller will negotiate each link independently; the older drive runs at 3.0 Gb/s while this drive operates at its rated 6.0 Gb/s.
How can I confirm the digitally signed firmware is active after installation?
Check the drive’s firmware revision in the system BIOS or HPE management software — it should match the signed version listed on the HPE support page for part MB4000GVYZK.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
