NEMIX RAM DDR5-5600 2TB (16x128GB) ECC RDIMM CL46 1.1V Supermicro H14SST-G memory upgrade
- 2TB (16 x 128GB)
- 288-Pin DDR5 RDIMM
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
KHACHIMO
A 220 W Flex ATX power supply with 80 PLUS Gold efficiency, Modern Standby support, Zero RPM fan mode and resonant LLC topology with DC-to-DC conversion for clean, quiet power
This KHACHIMO Flex ATX unit fits 1U and small-form-factor cases where a standard PSU will not install. It delivers 220W of continuous power for thin clients, embedded systems, or low-profile desktop builds. The 80 PLUS Gold rating keeps efficiency high and waste heat low in tight enclosures.
Swapping out an earlier Flex ATX supply that lacks Modern Standby support gives faster wake-from-sleep and better low-load efficiency. The resonant LLC topology with DC-to-DC conversion also reduces coil whine and enables deeper sleep states. The upgrade is worthwhile when the existing unit cannot meet current standby requirements or runs audibly loud at idle.
Measure the available depth in your chassis to confirm a 1U form factor will seat without cable interference. Check that the 5-wire harness matches the motherboard power headers used by your platform. Ensure the total system draw stays within the 220W rating so the zero-RPM fan mode can engage at low and medium loads.
| Type | ATX |
|---|
The power supply follows the Flex ATX form factor, which is designed for 1U and small-form-factor cases that accept Flex ATX units.
Connect the 24-pin ATX motherboard cable and the 4-pin or 8-pin CPU power cable; the step often missed is seating the CPU power connector fully so Modern Standby wake signals work reliably.
Listen for new rattling or grinding noises once the fan spins up under load; if the noise persists after dust removal, the bearing is wearing and the fan should be replaced.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?