We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green circuit board with black memory chips, gold edge connector, no heat spreader

NEMIX RAM

NEMIX RAM 16GB DDR4 2666 ECC UDIMM CL19 1.2V 288-pin memory upgrade for Synology RS2423RP+

SKU CH-B2FS-NY7Y3

16 GB DDR4 2666 ECC UDIMM CL19 1.2 V 288-pin module for Synology RS2423RP+ NAS

  • Capacity16GB
  • SpeedDDR4 2666 (PC4 21300)
  • ECCYes
  • Buffered/RegisteredUnbuffered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.20V
  • 16 GB DDR4 capacity expands Synology RS2423RP+ memory
  • ECC protection guards data integrity in NAS workloads
  • 2666 MHz speed matches system-rated PC4-21300 performance
  • 2 V low voltage reduces power draw and heat
  • 288-pin UDIMM form factor fits Synology Rackstation slots

Synology RS2423RP+ 16 GB DDR4 ECC UDIMM

This NEMIX RAM module adds 16 GB of DDR4 2666 memory with ECC protection to the Synology RackStation RS2423RP+. It runs at 1.2 V with CL19 timing and uses a 288-pin unbuffered design validated for that specific NAS platform.

Suited for RS2423RP+ owners needing ECC capacity

The stick targets administrators expanding a single RS2423RP+ unit. Builders working with other NAS models, desktop boards or servers that require registered DIMMs, different speeds or non-ECC memory should look at alternatives.

Fits the RS2423RP+ DIMM slots directly

No heat spreader means standard clearance inside the rack chassis. The 2Rx8 organisation works with the system memory controller, leaving any remaining slots free for further identical modules if the platform supports them.

Highlights

  • 16 GB DDR4 capacity expands Synology RS2423RP+ memory
  • ECC protection guards data integrity in NAS workloads
  • 2666 MHz speed matches system-rated PC4-21300 performance
  • 2 V low voltage reduces power draw and heat
  • 288-pin UDIMM form factor fits Synology Rackstation slots

Specifications

BrandNEMIX RAM
SeriesSynology Compatible Series NAS Memory
ModelSynology DDR4 2666MHZ ECC Unbuffered UDIMM
Part NumberME21300-628K1
Capacity16GB
SpeedDDR4 2666 (PC4 21300)
ECCYes
Buffered/RegisteredUnbuffered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.20V
Compatible SystemSynology
CAS LatencyCL19
Heat SpreaderNo
Type288-Pin DDR4 ECC UDIMM
Rank2Rx8
FeaturesDDR4 ECC Unbuffered UDIMM Motherboard Compatible
Package Content16GB (1X16GB) DDR4 2666MHZ PC4-21300 2Rx8 1.2V CL19 288-PIN ECC Unbuffered UDIMM

Questions about this item

Does the Synology RS2423RP+ need any specific BIOS setting or firmware version to recognise the 2666 MHz DDR4 ECC UDIMM?

The module is built to the Synology DDR4 2666 specification and installs without extra configuration; the NAS firmware detects the 2Rx8 ECC UDIMM automatically.

Can I mix this 16 GB 2666 MHz CL19 ECC stick with the factory 4 GB or 8 GB modules already in my RS2423RP+?

Yes, the NAS supports mixed capacities; the 2Rx8 1.2 V CL19 module will run at the lowest common speed alongside existing DDR4 ECC UDIMMs.

How do I confirm the new 16 GB DDR4 2666 ECC UDIMM is active and error-correcting after installation?

Open DSM Control Panel → Info Center → Memory; the total should show the added 16 GB and the status will list ECC as enabled.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.