SK hynix HMA42GR7AFR4N-TF 16GB DDR4 2133MHz CL15 ECC Registered Dual Rank 1.2V 288-Pin Server RAM
- 16GB
- 288-Pin DDR4 SDRAM
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
NEMIX RAM
32 GB kit of two 16 GB DDR4 SODIMM modules running at 2133 MHz CL15 for POSIFLEX terminals
This 32 GB kit contains two 16 GB modules built for the POSIFLEX XT-6315E JIVA high-end fanless POS terminal. It uses DDR4 2133 unbuffered non-ECC silicon from major OEM suppliers to match the platform's memory controller. The 260-pin form factor fits the terminal's SODIMM slots directly. Buyers who need ECC error correction or registered modules cannot use this kit.
Each module runs at 1.20 V with CL15 timing at the rated 2133 MT/s speed. The absence of a heat spreader keeps the profile thin for the fanless chassis while the low voltage limits thermal output. Power draw stays modest under typical point-of-sale workloads. Builders who require higher-frequency memory or overclocking headroom should look elsewhere.
The 2Rx8 organisation populates both ranks per module for maximum density in two slots. Standard gold-edge 260-pin connectors ensure reliable seating during upgrades. No extra cables, brackets or software are required for installation. Systems that only accept single-rank SODIMMs or that need a 288-pin DIMM will not accept these modules.
| Brand | NEMIX RAM |
|---|---|
| Series | POSIFLEX POS Series Point of Sale Kiosk Memory |
| Model | POSIFLEX POS DDR4 2133MHZ Non-ECC Unbuffered SODIMM |
| Part Number | MS17000-628K2 |
| Capacity | 32GB (2 x 16GB) |
| Speed | DDR4 2133 (PC4 17000) |
| ECC | No |
| Buffered/Registered | Unbuffered |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Voltage | 1.20V |
| Compatible System | POSIFLEX POS |
| CAS Latency | CL15 |
| Heat Spreader | No |
| Type | 260-Pin DDR4 SODIMM |
| Rank | 2Rx8 |
| Features | DDR4 Non-ECC Unbuffered SODIMM Motherboard Compatible |
| Package Content | 32GB (2X16GB) DDR4 2133MHZ PC4-17000 2Rx8 1.2V CL15 260-PIN Non-ECC Unbuffered SODIMM KIT |
Power off the terminal, remove the memory cover, align the notch on each 260-pin module with the slot key, press firmly until both side clips click, then replace the cover before powering on.
No routine maintenance is required; the modules have no heat spreader and run at 1.20V, so replacement is only needed if a module fails or capacity must increase.
The DDR4 2133 speed and CL15 latency set the bandwidth ceiling, so sustained throughput is limited by the 17000 MT/s transfer rate before thermal throttling occurs.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?