SK hynix HMA42GR7AFR4N-TF 16GB DDR4 2133MHz CL15 ECC Registered Dual Rank 1.2V 288-Pin Server RAM
- 16GB
- 288-Pin DDR4 SDRAM
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
NEMIX RAM
A 32 GB DDR4 3200 ECC registered DIMM built for Supermicro servers and workstations
This 32 GB DDR4 registered DIMM adds ECC-protected memory to compatible Supermicro servers and workstations. It is built for IT professionals who need single-module capacity upgrades in mission-critical environments.
The module runs at 1.2 V without a heat spreader, relying on chassis airflow for cooling. Registered buffering and ECC logic add minimal overhead, keeping power draw low during sustained server workloads.
The 2Rx8 organisation and CL22 latency at 3200 MT/s determine whether this DIMM matches the memory controller requirements of the target Supermicro platform. Builders needing different rank structures or lower latency should look elsewhere.
| Brand | NEMIX RAM |
|---|---|
| Series | SuperMicro Server/Workstation Compatible Series Memory |
| Model | SuperMicro DDR4 3200MHZ ECC RDIMM Registered Server Memory |
| Part Number | MR25600-328K1 |
| Capacity | 32GB |
| Speed | DDR4 3200 (PC4 25600) |
| ECC | Yes |
| Buffered/Registered | Registered |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Voltage | 1.20V |
| Compatible System | Supermicro |
| CAS Latency | CL22 |
| Heat Spreader | No |
| Type | 288-Pin DDR4 RDIMM |
| Rank | 2Rx8 |
| Features | DDR4 ECC Registered RDIMM Server Motherboard Compatible |
| Package Content | 32GB (1X32GB) DDR4 3200MHZ PC4-25600 2Rx8 1.2V CL22 288-PIN ECC RDIMM Registered Server Memory |
Power down, open the chassis, align the notch on the 288-Pin edge connector with the DIMM slot key, press firmly until both ejector tabs click shut, then verify in BIOS that the module registers at 3200 MT/s and ECC is active; the step most often missed is confirming the registered timing and ECC status in firmware after boot.
No scheduled maintenance is required; the module has no heat spreader and runs at 1.20 V, so only periodic dust removal from the DIMM slots is advised, and replacement occurs only if a memory test reports uncorrectable errors or the server platform is upgraded beyond DDR4.
The CAS latency of CL22 at 3200 MT/s sets the primary latency ceiling, while the dual-rank 2Rx8 organisation and registered buffer add minor command overhead; thermal throttling is unlikely at 1.20 V without a heat spreader, so latency remains the first observable bottleneck.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?