We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green bare circuit board DDR4 UDIMM with black memory chips and gold edge connector

NEMIX RAM

NEMIX RAM 32GB DDR4 3200 ECC UDIMM CL22 2Rx8 1.2V 288-Pin SuperMicro X12STL-IF memory upgrade

SKU CH-GWPZ-TDK08

A 32GB DDR4 3200 ECC UDIMM module with CL22 latency, 2Rx8 organisation, 1.2V operation and 288-pin layout for SuperMicro X12STL-IF systems

  • Capacity32GB
  • SpeedDDR4 3200 (PC4 25600)
  • ECCYes
  • Buffered/RegisteredUnbuffered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.20V
  • ECC protection safeguards data integrity in critical workloads
  • 3200 MHz DDR4 speed handles demanding server applications
  • 32 GB single module maximises capacity per slot
  • 2 V operation reduces power draw and heat
  • Validated for SuperMicro X12STL-IF ensures reliable compatibility

32GB DDR4 3200 ECC UDIMM for SuperMicro X12STL-IF

This 32GB DDR4 3200 ECC unbuffered UDIMM is built for the SuperMicro X12STL-IF platform. It runs at 1.2V with CL22 timing in a 2Rx8 layout. The module uses major OEM chips from Samsung, Micron or Hynix and carries no heat spreader.

Suited for ECC server and workstation upgrades

Buyers needing ECC memory for a SuperMicro X12STL-IF system will find this module a direct fit. It is not for platforms that require registered or load-reduced DIMMs. It is also not for systems limited to lower speeds or non-ECC memory. Builders wanting RGB lighting or a heat spreader should look elsewhere.

Simple DIMM installation with standard precautions

Installation follows the usual DIMM slot procedure: align the notch, press until the clips lock, and verify seating. The main issues are mixing ECC with non-ECC modules or populating slots in an order the board manual does not support. Always power down and ground yourself before handling the module.

Highlights

  • ECC protection safeguards data integrity in critical workloads
  • 3200 MHz DDR4 speed handles demanding server applications
  • 32 GB single module maximises capacity per slot
  • 2 V operation reduces power draw and heat
  • Validated for SuperMicro X12STL-IF ensures reliable compatibility

Specifications

BrandNEMIX RAM
SeriesSuperMicro Server/Workstation Compatible Series Memory
ModelSuperMicro DDR4 3200MHZ ECC Unbuffered UDIMM
Part NumberME25600-328K1
Capacity32GB
SpeedDDR4 3200 (PC4 25600)
ECCYes
Buffered/RegisteredUnbuffered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.20V
Compatible SystemSupermicro
CAS LatencyCL22
Heat SpreaderNo
Type288-Pin DDR4 ECC UDIMM
Rank2Rx8
FeaturesDDR4 ECC Unbuffered UDIMM Motherboard Compatible
Package Content32GB (1X32GB) DDR4 3200MHZ PC4-25600 2Rx8 1.2V CL22 288-PIN ECC Unbuffered UDIMM

Questions about this item

Does my SuperMicro X12STL-IF motherboard need a free 288-pin DDR4 slot to accept this 32GB module?

Yes, the module is a 288-pin DDR4 ECC UDIMM, so an available DDR4 UDIMM slot on the X12STL-IF is required.

Can I keep my existing DDR4 3200 ECC UDIMM sticks and add this CL22 2Rx8 module alongside them?

The board will run all installed DDR4 ECC UDIMMs at the lowest common speed and timings; mixing CL22 2Rx8 with other ranks or latencies is supported but may lower overall performance.

How do I confirm the system sees the full 32GB at 3200 MT/s with ECC active after installation?

Check the BIOS memory information or run a hardware utility such as dmidecode or CPU-Z; it should report 32GB, DDR4-3200, ECC enabled, and the correct part number.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.