We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green circuit board SODIMM module with black memory chips, 260 pins, no heat spreader

NEMIX RAM

NEMIX RAM 32GB DDR4 3200 SODIMM POSIFLEX JK-2752 memory upgrade

SKU CH-4AX3-16TWV

32GB DDR4 3200 SODIMM for POSIFLEX JK-2752 kiosk, CL22 1.2V unbuffered non-ECC

  • Capacity32GB
  • SpeedDDR4 3200 (PC4 25600)
  • ECCNo
  • Buffered/RegisteredUnbuffered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.20V
  • 32 GB capacity lifts multitasking headroom for kiosk workloads
  • DDR4 3200 speed matches POSIFLEX JK-2752 memory bus
  • 20 V operation keeps power draw low in always-on terminals
  • 260-pin SODIMM form factor fits the Cachet Series slot directly
  • CL22 latency rated for stable operation under continuous load

Compatible upgrade for POSIFLEX JK-2752

This SODIMM module is built specifically for the POSIFLEX JK-2752 Cachet Series kiosk. It delivers a 32GB capacity upgrade using standard DDR4 technology. The single-module design fits the 260-pin slot found in the target system. It is intended for technicians maintaining or expanding memory in this specific point-of-sale hardware.

32GB single module at DDR4 3200

The kit provides 32GB in a single 1x32GB configuration operating at 3200 MT/s (PC4-25600). It uses a 2Rx8 rank organisation with CL22 latency at 1.2V. This density fills one slot completely, leaving no room for additional modules if the board has only one SODIMM socket. Systems requiring more than 32GB total capacity cannot be served by this part.

Low-voltage operation without heat spreader

The module runs at 1.20V with no heat spreader attached, relying on the kiosk chassis airflow for cooling. As an unbuffered non-ECC SODIMM, it draws minimal power during typical point-of-sale workloads. Silent operation is inherent with no moving parts. The bare PCB design keeps the profile slim for tight kiosk enclosures.

Highlights

  • 32 GB capacity lifts multitasking headroom for kiosk workloads
  • DDR4 3200 speed matches POSIFLEX JK-2752 memory bus
  • 20 V operation keeps power draw low in always-on terminals
  • 260-pin SODIMM form factor fits the Cachet Series slot directly
  • CL22 latency rated for stable operation under continuous load

Specifications

BrandNEMIX RAM
SeriesPOSIFLEX POS Series Point of Sale Kiosk Memory
ModelPOSIFLEX POS DDR4 3200MHZ Non-ECC Unbuffered SODIMM
Part NumberMS25600-328K1
Capacity32GB
SpeedDDR4 3200 (PC4 25600)
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.20V
Compatible SystemPOSIFLEX POS
CAS LatencyCL22
Heat SpreaderNo
Type260-Pin DDR4 SODIMM
Rank2Rx8
FeaturesDDR4 Non-ECC Unbuffered SODIMM Motherboard Compatible
Package Content32GB (1X32GB) DDR4 3200MHZ PC4-25600 2Rx8 1.2V CL22 260-PIN Non-ECC Unbuffered SODIMM

Questions about this item

Will the 32GB DDR4 3200 SODIMM run at 1.2V alongside my existing lower-density DDR4 modules in the POSIFLEX JK-2752?

Yes, the module operates at 1.20V DDR4 standard voltage, so it will run at the same voltage as other DDR4 SODIMMs already installed in the JK-2752.

How can I verify the CL22 2Rx8 module is recognised at 3200 MT/s after installation?

Enter the system BIOS or use a tool such as CPU-Z; the memory tab should show 3200 MT/s, CL22 timings and 2Rx8 organisation for the new 32GB stick.

Does the MS25600-328K1 package include any mounting brackets or tools, or is it just the bare SODIMM?

The package contains only the single 32GB 260-pin DDR4 SODIMM; no brackets, screws or tools are supplied.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.