We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green circuit board with black memory chips, gold edge connector, small rectangular SODIMM form factor

NEMIX RAM

NEMIX RAM 8GB DDR4 2400 PC4-19200 1Rx8 1.2V 260-PIN Non-ECC SODIMM server RAM

SKU CH-58F9-4DBW2

8GB DDR4 2400 SODIMM module for server memory upgrades using standard 260-pin layout

  • Capacity8GB
  • Type204-Pin DDR3 SODIMM
  • SpeedDDR4 2400 (PC4 19200)
  • Voltage1.20V
  • ECCNo
  • Buffered/RegisteredUnbuffered
  • 8 GB capacity for demanding server workloads
  • DDR4 2400 speed with PC4-19200 bandwidth
  • 20 V low-voltage operation reduces power draw
  • 260-pin SODIMM form factor fits compatible Supermicro systems
  • Built with major OEM chips and stress tested for reliability

Server-ready DDR4 SODIMM

This 8 GB DDR4 2400 module targets IT teams upgrading Supermicro servers and compatible workstations. The single 1Rx8 stick delivers 19200 MB/s bandwidth at standard 1.2 V operation. Unbuffered non-ECC design suits platforms that do not require registered memory. Builders needing higher density or ECC protection should look elsewhere.

JEDEC-standard green PCB

The 260-pin SODIMM fits slim 1U and blade chassis without a heat spreader. Major OEM Samsung, Micron or Hynix ICs are stress-tested under load before shipping. Unbuffered layout keeps signal paths short for stable POST in dense configurations. Systems requiring 204-pin DDR3 or registered DIMMs cannot accept this module.

Cool, quiet, low-power operation

Bare DRAM packages run at 1.20 V with no active cooling needed. Passive airflow in a populated server tray is sufficient for continuous 2400 MT/s throughput. Power draw stays minimal, leaving headroom for populated memory channels. Enclosures with restricted airflow should still verify thermal limits independently.

Highlights

  • 8 GB capacity for demanding server workloads
  • DDR4 2400 speed with PC4-19200 bandwidth
  • 20 V low-voltage operation reduces power draw
  • 260-pin SODIMM form factor fits compatible Supermicro systems
  • Built with major OEM chips and stress tested for reliability

Specifications

BrandNEMIX RAM
SeriesSupermicro Series Server Memory
ModelSupermicro Compatible DDR3 SODIMM
Part NumberMS19200-818K1
Capacity8GB
Type204-Pin DDR3 SODIMM
SpeedDDR4 2400 (PC4 19200)
Voltage1.20V
ECCNo
Buffered/RegisteredUnbuffered
Rank2Rx8
ChipsetMajor OEM Samsung, Micron, Hynix
Heat SpreaderNo
FeaturesDDR3 Unbuffered SODIMM Motherboard Compatible

Questions about this item

Does the PC4-19200 rating limit the DDR4 2400 module to 19200 MB/s bandwidth?

PC4-19200 is the JEDEC designation for DDR4 2400, so the peak transfer rate is 19200 MB/s.

Will the 204-pin SODIMM fit a laptop slot keyed for 260-pin DDR4 modules?

No, the module uses a 204-pin DDR3 SODIMM form factor which is physically incompatible with 260-pin DDR4 slots.

What is the correct way to seat this unbuffered SODIMM and what step is often missed?

Align the notch with the slot key, insert at an angle, then press down firmly until both side clips click; the step often missed is pushing hard enough to engage both clips fully.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.