SK hynix HMA42GR7AFR4N-TF 16GB DDR4 2133MHz CL15 ECC Registered Dual Rank 1.2V 288-Pin Server RAM
- 16GB
- 288-Pin DDR4 SDRAM
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
NEMIX RAM
8GB DDR4 2400 ECC UDIMM with CL17 latency and 1.2V operation for Lenovo systems
This 8 GB DDR4 module is built for Lenovo servers and workstations that require error-correcting memory. It operates at 2400 MHz with a CL17 latency and runs on the standard 1.2 V. The unbuffered design suits platforms that do not support registered DIMMs.
The stick uses a 1Rx8 organisation with major OEM chips from Samsung, Micron or Hynix and has no heat spreader. Its low-profile height fits dense chassis where taller modules would block airflow or adjacent slots. Installation follows the usual UDIMM procedure without extra cabling.
Upgrading from standard unbuffered memory adds single-bit error correction for data integrity in critical workloads. The jump is worthwhile when the motherboard supports ECC and the current kit runs below 2400 MHz or lacks parity protection.
| Brand | NEMIX RAM |
|---|---|
| Series | Lenovo Server/Workstation Compatible Series Memory |
| Model | Lenovo DDR4 2666MHZ ECC Unbuffered UDIMM |
| Part Number | ME19200-818K1 |
| Capacity | 8GB |
| Speed | DDR4 2400 (PC4 19200) |
| ECC | Yes |
| Buffered/Registered | Unbuffered |
| Chipset | Major OEM Samsung, Micron, Hynix |
| Voltage | 1.20V |
| Compatible System | Lenovo |
| CAS Latency | CL17 |
| Heat Spreader | No |
| Type | 288-Pin DDR4 ECC UDIMM |
| Rank | 1Rx8 |
| Features | DDR4 2666MHZ ECC Unbuffered UDIMM Motherboard Compatible |
| Package Content | 8GB (1X8GB) DDR4 2400MHZ PC4-19200 1Rx8 1.2V CL17 288-PIN ECC Unbuffered UDIMM |
The module is rated for DDR4 2400 (PC4-19200) at 1.20 V with CL17 latency; the system will clock it to the highest supported speed up to that limit.
It uses a standard 288-pin DDR4 UDIMM slot; the single notch position matches the DDR4 keying so it only fits one way.
Align the notch with the slot key, press straight down until both side clips click, then verify the module sits evenly before powering on.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?