SK hynix HMA42GR7AFR4N-TF 16GB DDR4 2133MHz CL15 ECC Registered Dual Rank 1.2V 288-Pin Server RAM
- 16GB
- 288-Pin DDR4 SDRAM
We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.
OWC
16GB DDR4 3200 ECC Registered RDIMM 2Rx8 1.2V CL22 module compatible with Dell AA783421 AA799064 AA810826 AB214251 servers
This 16 GB DDR4 3200 module is an ECC registered RDIMM built to match Dell part numbers AA783421, AA799064, AA810826 and AB214251. It targets administrators upgrading or repairing compatible Dell PowerEdge servers and precision workstations that require registered memory with error correction. The 288-pin form factor fits standard DDR4 server slots.
Rated at PC4-25600 with CL22 latency, the module runs at the JEDEC-standard 1.2 V without overclocking headroom. Registered buffering reduces electrical load on the memory controller, helping signal integrity when all channels are populated. ECC circuitry detects and corrects single-bit errors continuously, which matters during long compute jobs or virtualization workloads. The 2Rx8 organisation distributes density across two ranks per module.
Installation follows normal DIMM seating procedure: align the notch, press until the ejectors click, and verify population order in the server service guide. Mixing these registered DIMMs with unbuffered memory will prevent boot or cause instability, so populate channels with identical modules. No heat spreader is fitted, so airflow across the PCB must be adequate in dense chassis configurations. The part is validated against the listed Dell part numbers for warranty-safe upgrades.
| Brand | OWC |
|---|---|
| Part Number | 3R2D42R816GB |
| Capacity | 16GB |
| Type | 288-Pin DDR4 ECC RDIMM |
| Speed | DDR4 3200 (PC4 25600) |
| CAS Latency | CL22 |
| Voltage | 1.2V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx8 |
| Heat Spreader | No |
At 1.2 volts the 16 GB RDIMM operates within standard DDR4 3200 power limits; registered buffering and ECC add minimal overhead so sustained load stays within the platform DIMM-slot budget.
The board must accept 288-pin DDR4 registered ECC RDIMMs at 3200 MT/s with 2Rx8 organisation; it will not work with unbuffered or non-ECC slots.
Mixing ranks is not recommended; OWC advises identical capacity speed and manufacturer per channel, so replace the 1Rx4 DIMMs or run them in separate channels only.
Also in this aisle
Same shelf, same checkout — eight coins and a 30-minute rate lock.
What you pay in, and what you read prices in.
Sent from your wallet at checkout
Display only — the catalogue is priced in USD
No currency matches that.
Pick the language the site speaks to you in.
New here?
Already have one?
There is no automatic reset: this shop sends no mail, so there is no one-time link to ask for. Leave the address on the account and it gets picked up by hand.
Request noted
Nothing is on its way to your inbox — this shop sends no mail at all. Someone picks these up by hand.
Remembered it?