We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Three green DDR2 DIMM modules with gold contacts and silver heatspreaders

Simmtec, Inc

Simmtec, Inc MemoryMasters 6GB (3 x 2GB) DDR2 DIMM 240 PIN 667MHz PC2 5400/5300 for Biostar TF8200 A2+

SKU CH-W36D-NX626

A 6 GB DDR2 kit of three 2 GB DIMMs running at 667 MHz and rated PC2 5400 or PC2 5300 for the Biostar TF8200 A2+ motherboard

  • Capacity6GB (3 x 2GB)
  • 100% compatible with Biostar TF8200 A2+ motherboard
  • 6 GB total capacity in three 2 GB modules
  • DDR2 667 MHz PC2-5400/5300 speed rating
  • 240-pin DIMM form factor fits standard desktop slots

Simmtec MemoryMasters DDR2 kit for Biostar TF8200

This 6GB kit contains three 2GB DDR2 DIMMs built to run at 667MHz on the PC2 5400 and PC2 5300 standards. The 240-pin modules are verified for 100 percent compatibility with the Biostar TForce TF8200 A2+ motherboard. It suits owners of that specific board who need to populate three slots with matching capacity.

Thermals, noise and power draw in normal use

DDR2 memory operates without active cooling and produces no audible noise during typical desktop workloads. Power consumption stays low because the modules draw only the current required for standard JEDEC voltage operation. Heat output is minimal and handled passively by the motherboard airflow. Builders seeking RGB lighting or high-frequency overclocking headroom should look elsewhere.

Highlights

  • 100% compatible with Biostar TF8200 A2+ motherboard
  • 6 GB total capacity in three 2 GB modules
  • DDR2 667 MHz PC2-5400/5300 speed rating
  • 240-pin DIMM form factor fits standard desktop slots

Specifications

Capacity6GB (3 x 2GB)

Questions about this item

How do I install the 240‑pin DDR2 DIMMs in the Biostar TF8200 A2+ and what step is often missed?

Align each module's notch with the slot key, press straight down until both side clips click, then verify the 667 MHz speed is detected in BIOS — the step most people miss is seating all three sticks before powering on.

What maintenance or replacement will the 6GB DDR2 kit need later?

DDR2 memory has no moving parts; keep the slots dust‑free with compressed air and reseat the modules if the system fails to POST — no scheduled replacement is required.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.