Brute Networks
Brute Networks Z9H56AA 8GB DDR4-2400 CL15 1Rx8 1.20V Non-ECC SODIMM
An 8 GB DDR4 SODIMM running at 2400 MHz with CL15 latency and 1.2 V operation
- Capacity8GB
- Type288-Pin DDR4 SDRAM
- SpeedDDR4 2400 (PC4 19200)
- CAS LatencyCL15
- Voltage1.20V
- ECCYes
- 8 GB capacity adds headroom for multitasking
- DDR4 2400 MHz speed delivers responsive data rates
- CL15 latency keeps access times low
- 2 V operation reduces power draw
- 288-pin SODIMM form factor fits compatible laptop slots
HP-compatible DDR4 SODIMM for laptop upgrades
This 8 GB DDR4-2400 module uses the Z9H56AA part reference and runs at 1.2 V with CL15 latency. It is built from major-brand DRAM chips and is 100 % compatible with systems that accept this specification. The unregistered, non-ECC design suits standard laptop and compact workstation slots.
Thermals noise and power in normal use
Operating at the standard 1.20 V DDR4 voltage keeps heat output low inside thin chassis. The single-rank 1Rx8 organisation reduces electrical load on the memory controller, helping the system stay quiet during everyday multitasking. No active cooling is required for this module.
Replaces slower or smaller DDR4 SODIMMs
Swapping out a 4 GB stick or a lower-speed DDR4 module instantly adds capacity and bandwidth for heavier browser tabs, office suites and light creative workloads. The jump is worth it when the current memory limit forces frequent swapping to storage. Systems already at the maximum supported capacity or requiring registered ECC DIMMs cannot use this module.
Pontos fortes
- 8 GB capacity adds headroom for multitasking
- DDR4 2400 MHz speed delivers responsive data rates
- CL15 latency keeps access times low
- 2 V operation reduces power draw
- 288-pin SODIMM form factor fits compatible laptop slots
Especificações
| Brand | HP |
|---|---|
| Capacity | 8GB |
| Type | 288-Pin DDR4 SDRAM |
| Speed | DDR4 2400 (PC4 19200) |
| CAS Latency | CL15 |
| Voltage | 1.20V |
| ECC | Yes |
| Buffered/Registered | Unregistered |
| Rank | 1Rx8 |
| Chipset | Major Brand Chipset |
Perguntas sobre este artigo
How do I install this 288-pin DDR4 SODIMM and what step is often missed?
Align the notch with the slot key, press firmly until both side clips click, then verify the module sits flush — the clips must lock audibly or the contact pads will not seat.
What maintenance or replacement will this 1.20 V DDR4 module need later?
No routine maintenance is required; if errors appear, reseat the module and run a memory test — replacement is only needed if the module itself fails.
What limit appears first on this CL15 2400 MHz kit during sustained loads?
The CL15 latency at 2400 MHz sets the throughput ceiling; sustained heavy workloads will hit that bandwidth limit before thermal or voltage constraints arise.
Também nesta secção
Os clientes também compararam
Mesma prateleira, mesma finalização da compra — oito moedas e uma taxa bloqueada durante 30 minutos.
Mushkin Enhanced 4GB DDR2-800 CL6 SoDIMM Apple 971741A memory upgrade
SK hynix HYMD232M646C6-J 256MB DDR 333MHz PC2700 CL2.5 SODIMM laptop RAM
- 4GB (2 x 2GB)



