BONAEVER
BONAEVER 250W 12V 20.83A IP67 Waterproof LED Power Supply
Delivers 12V DC at 20.83A with IP67 waterproof protection and automatic safety recovery for outdoor LED lighting
- TypePower Supply
- Delivers 250 W at 12 V for demanding LED installations
- IP67 rating protects against dust and water ingress outdoors
- Built-in short-circuit, overload, over-voltage, over-current and over-temperature safeguards with auto-recovery
- Operates from −40 °C to 40 °C for extreme climates
- ≥85 % efficiency reduces heat and energy waste
250W 12V IP67 LED Driver
The BONAEVER unit delivers 250 watts at 12 volts DC with a 20.83 amp maximum current. It accepts an AC input between 90 and 150 volts at 47 to 63 hertz. The housing meets IP67 for dust and water protection and operates from -40 to 40 degrees Celsius. Efficiency is rated at 85 percent or higher.
Outdoor lighting installers and sign makers
This supply suits projects that need a rugged 12V source in exposed locations such as building facades, bridge railings, plazas or advertising structures. It is not intended for indoor-only desktop PC builds or for loads that require a different output voltage or a higher power rating than 250 watts.
Fits 12V LED strips, bulbs and modules
The 3.3 foot input lead and 8.66 inch output lead connect directly to mains wiring and low-voltage lighting runs. Free-air cooling and the sealed enclosure remove the need for a separate ventilated cabinet. Automatic protection against short circuit, overload, over-voltage, over-current and over-temperature resets itself once the fault clears.
商品特色
- Delivers 250 W at 12 V for demanding LED installations
- IP67 rating protects against dust and water ingress outdoors
- Built-in short-circuit, overload, over-voltage, over-current and over-temperature safeguards with auto-recovery
- Operates from −40 °C to 40 °C for extreme climates
- ≥85 % efficiency reduces heat and energy waste
商品規格
| Type | Power Supply |
|---|
商品問答
What input voltage and frequency range must my mains supply provide for this 250 W driver to operate?
The driver accepts AC 90-150 V at 47-63 Hz, matching common residential mains worldwide.
Will the IP67 rating protect the unit if I mount it alongside older non-waterproof 12 V LED strips?
Yes, the IP67 enclosure seals against dust and temporary immersion, so the driver stays protected even if adjacent strips lack waterproofing.
How can I verify the supply is delivering the rated 12 V 20.83 A after installation?
Measure the output cables with a multimeter under load; a steady 12 V DC reading confirms the driver is operating within its 250 W specification.
同類商品
顧客也比較過
同一分類,同一套結帳流程 — 支援八種加密貨幣,匯率鎖定 30 分鐘。



