我們接受加密貨幣付款 — 讓您持有的幣種也能買到真正的硬體設備。以加密貨幣付款，直接購入真正的硬體設備。 全球訂單滿 US$399，即享免費保險運送。簡約外箱，不印任何品牌標誌，從德國出貨。訂單滿 US$399，即享免費保險運送。 結帳一開始，您的匯率即鎖定 30 分鐘。匯率鎖定 30 分鐘。 每件商品皆原廠密封、序號經過核對，並享有 24 個月保固。原廠密封，保固 24 個月。

追蹤清單 登入
Two green 240-pin DDR3 DIMM modules without heat spreaders

Computer Memory Solutions

Computer Memory Solutions 8GB (2x4GB) DDR3 1333 ECC memory upgrade

SKU CH-FQBB-CBJPT

ECC DDR3 1333 MHz kit adds 8 GB across two unregistered DIMMs for Supermicro X9SCL boards

  • Capacity8GB (2 x 4GB)
  • Type240-Pin DDR3 SDRAM
  • SpeedDDR3 1333 (PC3 10600)
  • CAS LatencyCL9
  • Timing9-9-9
  • Voltage1.5V
  • ECC protection guards data integrity on critical workloads
  • 1333 MHz DDR3 speed matches the board specification
  • 240-pin unregistered DIMMs install directly in four slots
  • 8 GB kit (2×4 GB) leaves room to reach 32 GB
  • Tested compatible with Supermicro X9SCL series motherboards

Targeted ECC upgrade for Supermicro X9SCL

This 8 GB kit contains two 4 GB DDR3 ECC unregistered DIMMs validated for the Supermicro MBD-X9SCL-0, MBD-X9SCL-F-B and MBD-X9SCL-B boards. It serves administrators who need to populate empty slots or replace failed modules in those specific platforms without guesswork. Builders using other motherboards should verify their own qualified-vendor lists before purchasing.

Thermals noise and power in normal use

Each module operates at the standard 1.5 V DDR3 voltage with no heat spreader, relying on chassis airflow for cooling. The low-profile design adds no acoustic load and draws only the power defined by the JEDEC DDR3-1333 specification during typical server workloads.

Build quality and daily connectors

The 240-pin DIMMs use major-brand chips and a 2Rx8 organisation, fitting the four memory sockets on the target boards up to the 32 GB maximum. Installation follows the standard vertical DIMM slot procedure; no extra cables, brackets or software configuration are required beyond normal BIOS memory detection.

商品特色

  • ECC protection guards data integrity on critical workloads
  • 1333 MHz DDR3 speed matches the board specification
  • 240-pin unregistered DIMMs install directly in four slots
  • 8 GB kit (2×4 GB) leaves room to reach 32 GB
  • Tested compatible with Supermicro X9SCL series motherboards

商品規格

BrandComputer Memory Solutions
ModelCM5127210600ECCNRH2R8
Capacity8GB (2 x 4GB)
Type240-Pin DDR3 SDRAM
SpeedDDR3 1333 (PC3 10600)
CAS LatencyCL9
Timing9-9-9
Voltage1.5V
ECCYes
Buffered/RegisteredUnregistered
Rank2Rx8
ChipsetMajor Brand Chipset
Heat SpreaderNo
Compatible SystemSUPERMICRO MBD-X9SCL-0, MBD-X9SCL-F-B, MBD-X9SCL-B
Package Content2 Memory RAM Sticks

商品問答

How do I install the 240-pin DDR3 ECC modules into the four slots on my Supermicro X9SCL board, and what step is often missed?

Align the notch on each 240-pin DDR3 stick with the slot key, press down firmly until both side clips click, then verify in BIOS that all 8 GB are detected at 1333 MHz; the step often missed is seating both ends evenly so the clips engage fully.

What maintenance or replacement will the unregistered ECC kit need over its service life?

The modules have no heat spreaders and carry a limited lifetime warranty against manufacturing defects; no scheduled maintenance is required, and replacement would only occur if a stick fails the warranty exchange.

What limit appears first when the 1.5 V DDR3 1333 kit runs sustained workloads on the X9SCL platform?

The platform caps total memory at 32 GB across its four sockets, so the 8 GB kit itself will not hit a capacity ceiling, but the board’s 32 GB maximum is the first hard limit you would reach when expanding.

同類商品

顧客也比較過

同一分類，同一套結帳流程 — 支援八種加密貨幣，匯率鎖定 30 分鐘。