OWC 16GB DDR4 3200MHz CL22 1.2V 260pin SODIMM Alienware X17 R1
- 16GB
- 260-Pin DDR4 Non-EC…
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
A-Tech
8GB DDR3L 1600 ECC RDIMM 2Rx4 at 1.35V for server and workstation upgrades
This 8GB DDR3L 1600 module is a registered ECC DIMM built for server and workstation systems that require error-correcting memory. It runs at 1.35V low voltage with CL11 latency and a 2Rx4 organisation. The 240-pin form factor fits standard DDR3 server slots.
Administrators upgrading compatible platforms with validated DDR3L registered ECC memory will find this a direct match. Systems that need unbuffered DIMMs, higher frequencies, or non-ECC modules cannot use this part.
The module combines ECC error correction and register buffering in a dual-rank x4 configuration. This specific organisation is required by many server memory controllers for stable operation at full population.
| Brand | A-Tech |
|---|---|
| Capacity | 8GB |
| Speed | DDR3L 1600 (PC3L 12800) |
| CAS Latency | CL11 |
| Voltage | 1.35V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Rank | 2Rx4 |
| Chipset | Major Brand Chipset |
| Features | Major Brand Chips |
CL11 is the rated latency for this DDR3L 1600 module; the registered buffer and ECC logic add a cycle, but the limit under sustained use is the memory controller's maximum supported frequency and rank population rules, not the CAS figure alone.
At 1.35 V the DDR3L module draws less power than standard 1.5 V DDR3, reducing heat output; the registered driver adds slight consumption, but total thermal load stays within normal server DIMM limits for continuous operation.
A 240-pin DDR3 DIMM slot wired for registered ECC memory and a chipset or CPU memory controller that validates DDR3L 1.35 V 2Rx4 modules are required; consumer boards without registered-ECC support will not post.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟