OWC 16GB DDR4 3200MHz CL22 1.2V 260pin SODIMM Alienware X17 R1
- 16GB
- 260-Pin DDR4 Non-EC…
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
Kingston Technology Corp.
2GB DDR2 400 ECC registered server memory module with CL3 latency and 1.80V operation
This 2 GB Kingston ValueRAM stick is a 240‑pin DDR2 SDRAM DIMM rated at DDR2 400 (PC2 3200). It carries ECC and registered buffering for data integrity in server boards. The module runs at 1.80 V with CL3 latency and a single‑rank layout.
DDR2 memory tops out at 400 MT/s and 1.80 V, so bandwidth and capacity per slot are far below later generations. Registered DIMMs add one clock cycle of address buffering, which the memory controller must support. Mixing registered and unbuffered modules on the same channel will prevent the system from posting.
Verify that your motherboard explicitly lists DDR2 registered ECC support and accepts 240‑pin DIMMs at PC2 3200 speed. Confirm the board’s maximum capacity per slot and total populated slots, as many DDR2-era servers cap well below modern densities. Ensure the BIOS is updated to the latest revision for proper SPD recognition.
| Brand | Kingston |
|---|---|
| Series | ValueRAM |
| Model | KVR400D2S4R3/2G |
| Capacity | 2GB |
| Type | 240-Pin DDR2 SDRAM |
| Speed | DDR2 400 (PC2 3200) |
| CAS Latency | CL3 |
| Voltage | 1.80V |
| ECC | Yes |
| Buffered/Registered | Registered |
| Heat Spreader | No |
| Features | Single Rank |
| وزن الشحنة | 0.02 kg |
| أبعاد الطرد | 160 × 46 × 6 mm |
This ValueRAM stick is a single-rank 2GB module; single-rank puts less load on the memory controller and is preferred when populating many slots on a registered DDR2 server board.
The module runs at 400 MT/s with CL3 latency at 1.80 V, providing the standard DDR2 400 data rate for compatible registered ECC platforms.
The 240-pin registered DDR2 interface requires a motherboard that supports registered ECC DDR2; speed is capped at DDR2 400 and each DIMM presents a single-rank load to the memory controller.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟