OWC 16GB DDR4 3200MHz CL22 1.2V 260pin SODIMM Alienware X17 R1
- 16GB
- 260-Pin DDR4 Non-EC…
نقبل الدفع بالعملة المشفرة — لذلك يمكن للعملات الرقمية التي تملكها أن تشتري أجهزة حقيقية.ادفع بالعملة المشفرة، وأنفقها على أجهزة حقيقية. شحن مؤمن مجانا إلى كل أنحاء العالم لما يتجاوز 399 US$. صناديق شحن بسيطة بلا علامة تجارية، ترسل من ألمانيا.شحن مؤمن مجانا لما يتجاوز 399 US$. يُقفل سعرك لمدة 30 دقيقة بمجرد فتح صفحة الدفع.السعر مقفل لمدة 30 دقيقة. كل قطعة مختومة، ورقمها التسلسلي متحقق منه، ومشمولة بضمان 24 شهرا.مختوم، وبضمان 24 شهرا.
Replace Power
420W ATX power supply with SATA and dual ATX connectors for Compaq Presario desktops
The Replace Power RPSU-C99-41 is a 420W ATX unit built to match the original power module in Compaq Presario SR2013WM, SR2014HM, SR2015LA, SR2017CL and SR2017LA desktops. It delivers the exact wattage and form factor required by those systems. Builders working on other platforms or needing higher output should look elsewhere.
The grey chassis holds a single fan and supplies a fixed harness: one 15-inch SATA connector, one 14-inch ATX connector compatible with both 20-pin and 24-pin motherboards, one 14-inch 12V ATX connector, two 15-inch large power connectors, two 6-inch large power connectors and one 6-inch small power connector. Cable lengths are set, so routing space inside the case must accommodate the listed reaches.
Rated at 420W, the supply uses one fan to move air through the grey enclosure under normal load. Acoustic output and thermal behaviour follow the single-fan design at this wattage level. No modular cabling or alternative cooling modes are provided.
| Brand | Replace Power |
|---|---|
| Model | RPSU-C99-41 |
| Color | Grey |
| Type | ATX |
| Fans | 1 |
| Weight | 0.1 |
It supplies one 15-inch SATA connector, one 14-inch ATX connector supporting both 20-pin and 24-pin layouts, one 14-inch 12V ATX connector, two 15-inch large power connectors, two 6-inch large power connectors and one 6-inch small power connector.
The unit follows the standard ATX form factor and is listed as a direct replacement for the SR2013WM, SR2014HM, SR2015LA, SR2017CL and SR2017LA models, so it mounts in the same bay with the same screw pattern.
Fit the unit into the case and secure the screws, then plug the 14-inch ATX connector into the motherboard (20-pin or 24-pin), attach the 14-inch 12V ATX cable, connect the SATA lead to drives, and finally add the large and small peripheral connectors as needed.
أيضًا في هذا القسم
نفس القسم، ونفس صفحة الدفع — ثماني عملات رقمية وقفل سعر لمدة 30 دقيقة.
ما تدفعه، وما تُعرض به الأسعار.
يُرسَل من محفظتك عند إتمام الطلب
للعرض فقط — أسعار الكتالوج بالدولار الأمريكي
لا توجد عملة مطابقة.
اختر اللغة التي يخاطبك بها الموقع.
هل أنت جديد هنا؟
لديك حساب بالفعل؟
لا توجد إعادة تعيين تلقائية: هذا المتجر لا يُرسل أي بريد، فلا يوجد رابط لمرة واحدة يمكن طلبه. اترك العنوان في الحساب، وسيُعالَج الأمر يدويًا.
تم تسجيل الطلب
لا شيء في طريقه إلى بريدك الوارد — هذا المتجر لا يُرسل أي بريد إطلاقًا. يتولّى أحدهم معالجة هذه الطلبات يدويًا.
تذكّرتها؟